In the Linux kernel, the following vulnerability has been resolved:
xhci: sideband: don't dereference freed ring when removing sideband endpoint
xhci_sideband_remove_endpoint() incorrecly assumes that the endpoint is
running and has a valid transfer ring.
Lianqin reported a crash during suspend/wake-up stress testing, and
found the cause to be dereferencing a non-existing transfer ring
'ep->ring' during xhci_sideband_remove_endpoint().
The endpoint and its ring may be in unknown state if this function
is called after xHCI was reinitialized in resume (lost power), or if
device is being re-enumerated, disconnected or endpoint already dropped.
Fix this by both removing unnecessary ring access, and by checking
ep->ring exists before dereferencing it. Also make sure endpoint is
running before attempting to stop it.
Remove the xhci_initialize_ring_info() call during sideband endpoint
removal as is it only initializes ring structure enqueue, dequeue and
cycle state values to their starting values without changing actual
hardware enqueue, dequeue and cycle state. Leaving them out of sync
is worse than leaving it as it is. The endpoint will get freed in after
this in most usecases.
If the (audio) class driver want's to reuse the endpoint after offload
then it is up to the class driver to ensure endpoint is properly set up.
Metrics
Affected Vendors & Products
References
History
Sun, 25 Jan 2026 14:45:00 +0000
| Type | Values Removed | Values Added |
|---|---|---|
| Description | In the Linux kernel, the following vulnerability has been resolved: xhci: sideband: don't dereference freed ring when removing sideband endpoint xhci_sideband_remove_endpoint() incorrecly assumes that the endpoint is running and has a valid transfer ring. Lianqin reported a crash during suspend/wake-up stress testing, and found the cause to be dereferencing a non-existing transfer ring 'ep->ring' during xhci_sideband_remove_endpoint(). The endpoint and its ring may be in unknown state if this function is called after xHCI was reinitialized in resume (lost power), or if device is being re-enumerated, disconnected or endpoint already dropped. Fix this by both removing unnecessary ring access, and by checking ep->ring exists before dereferencing it. Also make sure endpoint is running before attempting to stop it. Remove the xhci_initialize_ring_info() call during sideband endpoint removal as is it only initializes ring structure enqueue, dequeue and cycle state values to their starting values without changing actual hardware enqueue, dequeue and cycle state. Leaving them out of sync is worse than leaving it as it is. The endpoint will get freed in after this in most usecases. If the (audio) class driver want's to reuse the endpoint after offload then it is up to the class driver to ensure endpoint is properly set up. | |
| Title | xhci: sideband: don't dereference freed ring when removing sideband endpoint | |
| First Time appeared |
Linux
Linux linux Kernel |
|
| CPEs | cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:* | |
| Vendors & Products |
Linux
Linux linux Kernel |
|
| References |
|
Status: PUBLISHED
Assigner: Linux
Published:
Updated: 2026-01-25T14:36:22.817Z
Reserved: 2026-01-13T15:37:45.939Z
Link: CVE-2026-23009
No data.
Status : Received
Published: 2026-01-25T15:15:55.767
Modified: 2026-01-25T15:15:55.767
Link: CVE-2026-23009
No data.
OpenCVE Enrichment
No data.