| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A security vulnerability has been detected in UTT HiPER 1200GW up to 2.5.3-170306. This impacts the function strcpy of the file /goform/pptpSrvGlobalConfig. Such manipulation of the argument EncryptionMode leads to stack-based buffer overflow. The attack can be executed remotely. The exploit has been disclosed publicly and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| In the Linux kernel, the following vulnerability has been resolved:
libceph: fix two unsafe bare decodes in decode_lockers()
decode_lockers() in cls_lock_client.c contains two bare decode operations
that allow a malicious or compromised OSD to trigger slab-out-of-bounds
reads:
1. ceph_decode_32(p) at the num_lockers field has no preceding bounds
check. ceph_start_decoding() accepts struct_len=0 as valid -- the
internal ceph_decode_need(p, end, 0, bad) always passes -- so when an
OSD sends struct_len=0, ceph_start_decoding() returns success with
p == end. The immediately following bare ceph_decode_32(p) then reads
4 bytes past the validated buffer boundary. The garbage value is
passed directly to kzalloc_objs() as the locker count.
The sibling function decode_watchers() in osd_client.c already uses
ceph_decode_32_safe() after its own ceph_start_decoding() call.
decode_lockers() was the only site using the bare variant.
2. ceph_decode_8(p) after the decode_locker() loop has no preceding
bounds check. If an OSD crafts num_lockers such that the loop
advances p exactly to end, the subsequent bare ceph_decode_8(p) reads
one byte past the validated buffer boundary. The result is passed
directly into *type, which is used as a lock type discriminator by
callers, giving an OSD-controlled one-byte OOB read with direct
influence over the lock type field.
Fix both by replacing bare operations with their safe variants:
ceph_decode_32(p) -> ceph_decode_32_safe(p, end, *num_lockers,
err_inval)
ceph_decode_8(p) -> ceph_decode_8_safe(p, end, *type,
err_free_lockers)
The goto targets differ intentionally:
err_inval: is a new label returning -EINVAL directly. It is used for
the pre-allocation failure path where *lockers is not yet allocated
and must not be passed to ceph_free_lockers().
err_free_lockers: is the existing label. It is used for the
post-allocation failure path where *lockers is allocated and must
be freed.
ret is set to -EINVAL before ceph_decode_8_safe() so that
err_free_lockers returns the correct error code on bounds violation.
Without this, err_free_lockers would return a stale ret value (0 from
the successful decode_locker() loop), silently swallowing the error.
-EINVAL is correct for both failure paths. The data received from the
OSD is structurally malformed. -ENOMEM would misrepresent the failure
class to callers and to stable@ backporters triaging error paths.
Attacker model: a malicious or compromised OSD in a multi-tenant Ceph
deployment can trigger this against any kernel client that issues the
lock.get_info class method (e.g. during RBD exclusive lock acquisition).
[ idryomov: trim changelog, formatting ] |
| A vulnerability has been found in MZ Automation libiec61850 up to 1.6.1. The affected element is the function MmsMapping_varAccessSpecToObjectReference of the file src/iec61850/common/iec61850_common.c of the component MMS Protocol Workflow. Such manipulation of the argument GetNamedVariableListAttributesResponse.itemId leads to heap-based buffer overflow. The attack must be carried out locally. The exploit has been disclosed to the public and may be used. The project was informed of the problem early through an issue report but has not responded yet. |
| A vulnerability was found in MZ Automation libiec61850 up to 1.6.1. The affected element is the function deleteDataSetValuesShadowBuffer of the file src/iec61850/server/mms_mapping/reporting.c of the component URCB Revalidation. The manipulation results in use after free. The attack needs to be approached locally. The exploit has been made public and could be used. Upgrading to version 1.6.2 is sufficient to fix this issue. The patch is identified as 486fd57f3aed65bb9d636ff00f9ddce2e450b168. Upgrading the affected component is advised. |
| A security flaw has been discovered in MZ Automation libiec61850 up to 1.6.1. This affects the function SVReceiver_stopThreadless of the file src/sampled_values/sv_subscriber.c of the component ASDU Element Handler. Performing a manipulation results in heap-based buffer overflow. The attack must be initiated from a local position. The exploit has been released to the public and may be used for attacks. Upgrading to version 1.6.2 is able to mitigate this issue. The patch is named a96bd674e0238276dd1387d31d52e55229d0771e. The affected component should be upgraded. |
| A flaw was found in the libXfont2 font-server client. A remote attacker, by operating a malicious font server, could exploit an out-of-bounds read/write vulnerability. This occurs because the client incorrectly handles font data, leading to an out-of-bounds memory access. This can lead to privilege escalation if the X server runs with root privileges, or a denial of service (crash) if it runs as an unprivileged user. |
| As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco IOS XE Software engineering team has conducted a comprehensive internal security review. This review resulted in software hardening releases that address multiple internally discovered vulnerabilities.
The vulnerabilities tracked by CVE-2026-20268 are related to issues with improper restriction of operations within the bounds of a memory buffer that are grouped under the Common Weakness Enumeration (CWE) Pillar CWE-119. |
| A security flaw has been discovered in UTT HiPER 1200GW up to v2.5.3-170306. This affects the function strcpy of the file /goform/ConfigAdvideo. The manipulation of the argument timestart results in stack-based buffer overflow. The attack can be launched remotely. The exploit has been released to the public and may be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was found in o6 open62541 up to 1.5.5. This issue affects the function UA_Client_readNodeClassAttribute of the file src/client/ua_client_highlevel.c. Performing a manipulation results in heap-based buffer overflow. Attacking locally is a requirement. The exploit has been made public and could be used. The project closed the issue report, stating that this is not the official way to report a security vulnerability. |
| A vulnerability was identified in UTT HiPER 1250GW up to v3.2.7-210907-180535. The impacted element is the function strcpy of the file /goform/getOneApConfTempEntry. The manipulation of the argument tempName leads to stack-based buffer overflow. The attack can be initiated remotely. The exploit is publicly available and might be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was found in UTT HiPER 1250GW up to 3.2.7-210907-180535. Impacted is the function strcpy of the file /goform/APSecurity_5g. Performing a manipulation of the argument cipher results in stack-based buffer overflow. It is possible to initiate the attack remotely. The exploit has been made public and could be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| The issue was addressed with improved memory handling. This issue is fixed in macOS Sequoia 15.7.8, macOS Sonoma 14.8.8. An attacker may be able to cause unexpected system termination or read kernel memory. |
| The issue was addressed with improved memory handling. This issue is fixed in macOS Sequoia 15.7.8, macOS Sonoma 14.8.8, macOS Tahoe 26.6. An attacker may be able to cause unexpected system termination or corrupt kernel memory. |
| The issue was addressed with improved memory handling. This issue is fixed in iOS 26.6 and iPadOS 26.6, macOS Tahoe 26.6, tvOS 26.6, visionOS 26.6, watchOS 26.6. An attacker in physical proximity may be able to corrupt process memory. |
| A type confusion issue was addressed with improved memory handling. This issue is fixed in macOS Sequoia 15.7.8, macOS Sonoma 14.8.8, macOS Tahoe 26.6. An app may be able to cause unexpected system termination. |
| The issue was addressed with improved memory handling. This issue is fixed in macOS Sequoia 15.7.8, macOS Sonoma 14.8.8, macOS Tahoe 26.6. An app may be able to cause unexpected system termination or read kernel memory. |
| The issue was addressed with improved memory handling. This issue is fixed in macOS Sequoia 15.7.8, macOS Sonoma 14.8.8, macOS Tahoe 26.6. A remote user may be able to cause unexpected system termination or corrupt kernel memory. |
| The issue was addressed with improved memory handling. This issue is fixed in macOS Sequoia 15.7.8, macOS Sonoma 14.8.8, macOS Tahoe 26.6. A remote user may be able to cause unexpected system termination or corrupt kernel memory. |
| A buffer overflow was addressed with improved bounds checking. This issue is fixed in iOS 26.6 and iPadOS 26.6, macOS Sequoia 15.7.8, macOS Tahoe 26.6, tvOS 26.6, visionOS 26.6. A remote attacker may be able to cause unexpected application termination or heap corruption. |
| The issue was addressed with improved memory handling. This issue is fixed in macOS Sequoia 15.7.8, macOS Sonoma 14.8.8, macOS Tahoe 26.6. An app may be able to cause unexpected system termination. |
