| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix stack slot index in nospec checks
check_stack_write_fixed_off() computes the byte slot for a fixed-offset
stack write as -off - 1, and records each written byte in slot_type[] with
(slot - i) % BPF_REG_SIZE.
The Spectre v4 sanitization pre-check uses slot_type[i] instead. For a
4-byte write at fp-8 after the lower half of fp-8 has been zeroed, the
pre-check scans bytes 0..3 and sees STACK_ZERO while the actual write updates
bytes 7..4. That can leave the second half-slot write without nospec_result
even though the bytes being overwritten still require sanitization.
Use the same slot index in the sanitization pre-check that the write path uses
when updating slot_type[]. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: FCP: Fix NULL pointer dereference in interface lookup
A malformed USB device can provide a vendor-specific interface without
any endpoint descriptors. fcp_find_fc_interface() currently selects the
first vendor-specific interface and reads endpoint 0 from it, without
checking whether the interface actually has any endpoints.
When bNumEndpoints is zero, no endpoint array is allocated for the parsed
alternate setting, so get_endpoint(..., 0) yields an invalid endpoint
descriptor pointer. Dereferencing it through usb_endpoint_num() then
triggers a NULL pointer dereference.
Skip vendor-specific interfaces that do not have any endpoints. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: adm1275: Prevent reading uninitialized stack
While adding support for the ROHM BD127X0 hot-swap controllers, sashiko
reported an error in device-name comparison, which can lead to reading
uninitialized stack memory.
Quoting Sashiko:
This is a pre-existing issue, but I noticed that just before this block in
adm1275_probe(), there might be an out-of-bounds stack read:
ret = i2c_smbus_read_block_data(client, PMBUS_MFR_MODEL, block_buffer);
if (ret < 0) { ... }
for (mid = adm1275_id; mid->name[0]; mid++) {
if (!strncasecmp(mid->name, block_buffer, strlen(mid->name)))
break;
}
Since i2c_smbus_read_block_data() reads up to 32 bytes into the
uninitialized stack array block_buffer without appending a null
terminator, strncasecmp() could read past the valid bytes returned in ret.
For example, if the device returns a shorter string like "adm12", checking
it against "adm1275" up to the length of "adm1275" will continue reading
into uninitialized stack bounds.
Prevent reading uninitialized memory by zeroing the stack array. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Reject invalid indirect BO handle in indirect CSD setup
v3d_get_cpu_indirect_csd_params() looks up the indirect buffer object
from a userspace-supplied handle but never checks the result. A bogus
or stale handle makes drm_gem_object_lookup() return NULL, which is
then stored in info->indirect and only dereferenced later when the
indirect CSD job runs, turning a userspace mistake into a NULL pointer
dereference in the kernel.
Bail out with -ENOENT as soon as the lookup fails, so the bad handle is
rejected at submission time. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing/remotes: Fix leak in trace_remote_alloc_buffer() error path
If page allocation fails in trace_remote_alloc_buffer(), desc->nr_cpus
is not yet incremented for the current CPU. As a consequence, on error,
half-allocated rb_desc will not be freed in trace_remote_free_buffer().
Increment desc->nr_cpus as soon as the first allocation for the current
CPU has succeeded. |
| In the Linux kernel, the following vulnerability has been resolved:
VDUSE: avoid leaking information to userspace
The bounceing is not necessarily page aligned, so current VDUSE can
leak kernel information through mapping bounce pages to
userspace. Allocate bounce pages with __GFP_ZERO to avoid leaking
information to userspace. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Initialize KVM_S390_GET_CMMA_BITS memory
kvm_s390_get_cmma_bits() allocates its output buffer with vmalloc(),
which does not zero the returned pages:
values = vmalloc(args->count);
In the non-peek (migration) path, dat_get_cmma() reports a byte count
spanning from the first to the last dirty page, but __dat_get_cmma_pte()
writes values[gfn - start] only for pages whose CMMA dirty bit is set.
The walk uses DAT_WALK_IGN_HOLES, so clean and unmapped pages that lie
between two dirty pages within the reported span are visited but never
store their byte. Those gaps (up to KVM_S390_MAX_BIT_DISTANCE pages
each) stay uninitialized yet fall inside [0, count) and are copied out
by copy_to_user(), disclosing stale kernel memory to user space.
Before the switch to the new gmap implementation the buffer was fully
populated for every gfn in the span, so no uninitialized bytes were
exposed; the dirty-only walk introduced the leak.
Use vzalloc() so the gaps read back as zero. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Fix device reference leak in host1x_device_parse_dt() error path
After device_initialize(), the embedded struct device in struct
host1x_device should be released through the device core with
put_device().
In host1x_device_add(), if host1x_device_parse_dt() fails, the current
error path frees the object directly with kfree(device). That bypasses
the normal device lifetime handling and leaks the reference held on the
embedded struct device.
The issue was identified by a static analysis tool I developed and
confirmed by manual review.
Fix this by using put_device() in the host1x_device_parse_dt() failure
path. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/boot: Validate console=uart8250 baud rate to fix early boot hang
When the baud rate is empty, 0, invalid, or overflows to 0 when stored
as an int, the system will hang during early boot because of a division
by zero in early_serial_init().
Fall back to DEFAULT_BAUD when the resulting baud rate is 0 to prevent
an early system hang. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix NULL h_transaction deref in ocfs2_assure_trans_credits
[BUG]
A direct write over unwritten extents can panic the kernel in
ocfs2_assure_trans_credits() when the journal aborts during DIO
completion. The crash is a general protection fault from a NULL pointer
dereference.
[CAUSE]
ocfs2_dio_end_io_write() loops over a direct write's unwritten extents,
marking each written under a single journal handle. If the journal
aborts (for example after an I/O error) while the extent tree is being
updated, the handle is left aborted with its transaction pointer
cleared. The extent merge treats that failure as not critical and
reports success, so the loop keeps using the handle.
ocfs2_assure_trans_credits() reads the handle's remaining credits
without first checking whether the handle is aborted, and that read
dereferences the cleared transaction pointer.
[FIX]
A journal abort is recorded in the handle itself, so callers are
expected to test the handle rather than rely on a returned error.
Make ocfs2_assure_trans_credits() do that, as the other ocfs2 journal
helpers already do, and return -EROFS when the handle is aborted. |
| In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix data race on rx_stamp/rx_ifindex in bcm_rx_handler()
For an rx op subscribed on all interfaces (ifindex == 0), the same op
is registered once in the shared per-netns wildcard filter list, so
bcm_rx_handler() can run concurrently on different CPUs for frames
arriving on different net devices.
op->rx_stamp and op->rx_ifindex were written before bcm_rx_update_lock was
taken, allowing concurrent writers to race each other - including a torn
store of the 64-bit rx_stamp on 32-bit platforms.
Beyond a torn store bcm_send_to_user() must report the timestamp/ifindex
of the very same frame whose content it is delivering. So the assignment
is placed in the same unbroken bcm_rx_update_lock section as the content
comparison.
As a side effect, the RTR-request frame feature (which never reach
bcm_send_to_user()) no longer updates rx_stamp/rx_ifindex, since only
the notification path needs them. |
| In the Linux kernel, the following vulnerability has been resolved:
dm-pcache: reject option groups without values
The pcache target parses optional arguments as name/value pairs. A
table that advertises one optional argument and supplies only a
recognized option name, for example "cache_mode", reaches
parse_cache_opts() with argc == 1. The parser consumes the name,
decrements argc to zero, then calls dm_shift_arg() again for the value.
dm_shift_arg() returns NULL when no arguments remain, and the following
strcmp() dereferences that NULL pointer.
Check that each recognized option has a value before consuming it. This
keeps valid "cache_mode writeback" and "data_crc true/false" tables
unchanged while making malformed tables fail during target construction
with a precise missing-value error. |
| In the Linux kernel, the following vulnerability has been resolved:
dm-integrity: fix leaking uninitialized kernel memory
If hash size is less than device's tuple size, dm-integrity is supposed
to zero the remaining space. There was a bug in the code that zeroing
didn't work. This commit fixes it. |
| In the Linux kernel, the following vulnerability has been resolved:
dm-verity: fix a possible NULL pointer dereference
Fix a possible NULL pointer dereference dm_verity_loadpin_is_bdev_trusted
if the device has no table. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: elx: efct: Fix I/O leak on unsupported additional CDB
efct_dispatch_fcp_cmd() allocates an efct_io before dispatching an
unsolicited FCP command. If the command has an unsupported additional
CDB, the function returns -EIO before handing the IO to the SCSI layer.
Free the allocated IO before returning from this error path. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix use-after-free and double-free in disconnect
ims_pcu_disconnect() only intended to perform cleanup when the primary
(control) interface is unbound. However, it currently relies on the
interface class to distinguish between control and data interfaces.
A malicious device could present a data interface with the same class
as the control interface, leading to premature cleanup and potential
use-after-free or double-free.
Switch to verifying that the interface being disconnected is indeed
the control interface. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix type confusion in CDC union descriptor parsing
The driver currently trusts the bMasterInterface0 from the CDC union
descriptor without verifying that it matches the interface being
probed. This could lead to the driver overwriting the private data of
another interface.
Validate that the control interface found in the descriptor is indeed
the one we are probing. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: libertas_tf: fix use-after-free in lbtf_free_adapter()
lbtf_free_adapter() calls timer_delete(&priv->command_timer), which does
not wait for a running command_timer_fn() callback. lbtf_free_adapter()
runs on the teardown path right before ieee80211_free_hw() frees priv,
both in lbtf_remove_card() and in the probe error path. command_timer is
armed by mod_timer() in lbtf_cmd() whenever a firmware command is sent.
command_timer_fn() dereferences priv. If a command times out as the
device is removed, command_timer_fn() runs concurrently with teardown and
dereferences priv after it has been freed.
This is the same use-after-free that commit 03cc8f90d053 ("wifi: libertas:
fix use-after-free in lbs_free_adapter()") fixed in the sibling libertas
driver. The libertas_tf variant has the identical pattern and was left
unchanged. Use timer_delete_sync() so any in-flight callback completes
before priv is freed. |
| In the Linux kernel, the following vulnerability has been resolved:
posix-cpu-timers: Use u64 multiplication in update_rlimit_cpu()
update_rlimit_cpu() converts the RLIMIT_CPU value to nanoseconds with
u64 nsecs = rlim_new * NSEC_PER_SEC;
On 32-bit kernels both rlim_new (unsigned long) and NSEC_PER_SEC
(1000000000L) are 32-bit, so the multiplication is performed in unsigned
long and truncated for rlim_new > 4 seconds before being widened to u64.
The same file already casts to u64 for the matching computation in
check_process_timers():
u64 softns = (u64)soft * NSEC_PER_SEC;
As a result, the truncated value is installed into the CPUCLOCK_PROF
expiry cache (nextevt), causing the process CPU timer to be programmed
to fire prematurely for any RLIMIT_CPU soft limit >= 5 seconds. The
actual SIGXCPU/SIGKILL decision in check_process_timers() already casts
to u64 and is therefore correct, so limit enforcement is not broken;
only the expiry-cache programming is wrong. Apply the same cast here so
both paths convert rlim_cur identically.
64-bit kernels are unaffected. |
