| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the access control list (ACL) processing of IPv4 packets of Cisco SD-WAN vEdge Software could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability is due to the improper enforcement of the implicit deny all at the end of a configured ACL. An attacker could exploit this vulnerability by attempting to send unauthorized traffic to an interface on an affected device. A successful exploit could allow the attacker to bypass an ACL on the affected device. |
| A vulnerability in the Device Analytics action frame processing of Cisco Wireless Access Point (AP) Software could allow an unauthenticated, adjacent attacker to inject wireless 802.11 action frames with arbitrary information.
This vulnerability is due to insufficient verification checks of incoming 802.11 action frames. An attacker could exploit this vulnerability by sending 802.11 Device Analytics action frames with arbitrary parameters. A successful exploit could allow the attacker to inject Device Analytics action frames with arbitrary information, which could modify the Device Analytics data of valid wireless clients that are connected to the same wireless controller. |
| A vulnerability in the IPv6 Router Advertisement (RA) packet processing of Cisco Access Point Software could allow an unauthenticated, adjacent attacker to modify the IPv6 gateway on an affected device.
This vulnerability is due to a logic error in the processing of IPv6 RA packets that are received from wireless clients. An attacker could exploit this vulnerability by associating to a wireless network and sending a series of crafted IPv6 RA packets. A successful exploit could allow the attacker to temporarily change the IPv6 gateway of an affected device. This could also lead to intermittent packet loss for any wireless clients that are associated with the affected device. |
| A vulnerability in the UDP packet validation code of Cisco SD-WAN vEdge Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition on an affected system.
This vulnerability is due to incorrect handling of a specific type of malformed UDP packet. An attacker in a machine-in-the-middle position could exploit this vulnerability by sending crafted UDP packets to an affected device. A successful exploit could allow the attacker to cause the device to reboot, resulting in a DoS condition on the affected system. |
| A vulnerability in the API endpoints of Cisco Integrated Management Controller could allow an authenticated, remote attacker to bypass authorization and take actions on a vulnerable system without authorization.
The vulnerability is due to improper authorization checks on API endpoints. An attacker could exploit this vulnerability by sending malicious requests to an API endpoint. An exploit could allow the attacker to download files from or modify limited configuration options on the affected system.There are no workarounds that address this vulnerability. |
| A vulnerability in the CLI of Cisco UCS Manager Software could allow an authenticated, local attacker with administrative privileges to read or create a file or overwrite any file on the file system of the underlying operating system of an affected device, including system files.
This vulnerability is due to insufficient input validation of command arguments supplied by the user. An attacker could exploit this vulnerability by authenticating to a device and submitting crafted input to the affected command. A successful exploit could allow the attacker to read or create a file or overwrite any file on the file system of the underlying operating system of the affected device, including system files. To exploit this vulnerability, the attacker must have valid administrative credentials on the affected device. |
| A vulnerability in Cisco Catalyst Center Virtual Appliance could allow an authenticated, remote attacker to elevate privileges to Administrator on an affected system.
This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by submitting a crafted HTTP request to an affected system. A successful exploit could allow the attacker to perform unauthorized modifications to the system, including creating new user accounts or elevating their own privileges on an affected system. To exploit this vulnerability, the attacker must have valid credentials for a user account with at least the role of Observer. |
| A security vulnerability was discovered in the local status page functionality of Cisco Meraki’s MX67 and MX68 security appliance models that may allow unauthenticated individuals to access and download logs containing sensitive, privileged device information. The vulnerability is due to improper access control to the files holding debugging and maintenance information, and is only exploitable when the local status page is enabled on the device. An attacker exploiting this vulnerability may obtain access to wireless pre-shared keys, Site-to-Site VPN key and other sensitive information. Under certain circumstances, this information may allow an attacker to obtain administrative-level access to the device. |
| A vulnerability in the GUI of Cisco Identity Services Engine (ISE) could allow an authenticated, remote attacker with administrative privileges to upload files to an affected device.
This vulnerability is due to improper validation of the file copy function. An attacker could exploit this vulnerability by sending a crafted file upload using the Cisco ISE GUI. A successful exploit could allow the attacker to upload arbitrary files to an affected system. |
| A vulnerability in the web-based management interface of Cisco Catalyst Center Virtual Appliance could allow an unauthenticated, remote attacker to redirect a user to a malicious web page.
This vulnerability is due to improper input validation of HTTP request parameters. An attacker could exploit this vulnerability by intercepting and modifying an HTTP request from a user. A successful exploit could allow the attacker to redirect the user to a malicious web page. |
| A vulnerability in the web UI of Cisco IOS Software could allow an authenticated, remote attacker with low privileges to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper input validation. An attacker could exploit this vulnerability by sending a crafted URL in an HTTP request. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| A vulnerability in the local interface of Cisco BroadWorks Network Server could allow an unauthenticated, remote attacker to exhaust system resources, causing a denial of service (DoS) condition.
This vulnerability exists because rate limiting does not occur for certain incoming TCP connections. An attacker could exploit this vulnerability by sending a high rate of TCP connections to the server. A successful exploit could allow the attacker to cause TCP connection resources to grow rapidly until the Cisco BroadWorks Network Server becomes unusable.
Note: To recover from this vulnerability, either Cisco BroadWorks Network Server software must be restarted or the Cisco BroadWorks Network Server node must be rebooted. For more information, see the section of this advisory.
Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability. |
| A vulnerability in the access control list (ACL) programming of Cisco IOS XE Software for Cisco Catalyst 9500X and 9600X Series Switches could allow an unauthenticated, remote attacker to bypass a configured ACL on an affected device.
This vulnerability is due to the flooding of traffic from an unlearned MAC address on a switch virtual interface (SVI) that has an egress ACL applied. An attacker could exploit this vulnerability by causing the VLAN to flush its MAC address table. This condition can also occur if the MAC address table is full. A successful exploit could allow the attacker to bypass an egress ACL on an affected device. |
| A vulnerability in Cisco IOS XE Software could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to an affected device to execute persistent code at boot time and break the chain of trust. This vulnerability is due to improper validation of software packages. An attacker could exploit this vulnerability by placing a crafted file into a specific location on an affected device. A successful exploit could allow the attacker to execute persistent code on the underlying operating system. Because this vulnerability allows an attacker to bypass a major security feature of a device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High. |
| Multiple vulnerabilities in Cisco IOS XE Software of could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to the device to execute persistent code at boot time and break the chain of trust.
These vulnerabilities are due path traversal and improper image integrity validation. A successful exploit could allow the attacker to execute persistent code on the underlying operating system.
Because this allows the attacker to bypass a major security feature of the device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High.
For more information about these vulnerabilities, see the Details ["#details"] section of this advisory.
ERP |
| A vulnerability in the handling of certain Ethernet frames in Cisco IOS XE Software for Catalyst 9000 Series Switches could allow an unauthenticated, adjacent attacker to cause an egress port to become blocked and drop all outbound traffic.
This vulnerability is due to improper handling of crafted Ethernet frames. An attacker could exploit this vulnerability by sending crafted Ethernet frames through an affected switch. A successful exploit could allow the attacker to cause the egress port to which the crafted frame is forwarded to start dropping all frames, resulting in a denial of service (DoS) condition. |
| A vulnerability in the web services interface of Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a buffer overflow on an affected system.
This vulnerability is due to insufficient boundary checks for specific data that is provided to the web services interface of an affected system. An attacker could exploit this vulnerability by sending a crafted HTTP request to the affected system. A successful exploit could allow the attacker to cause a buffer overflow condition on the affected system, which could cause the system to reload, resulting in a denial of service (DoS) condition. |
| A vulnerability in the installation process of Cisco IOS XR Software could allow an authenticated, local attacker to bypass Cisco IOS XR Software image signature verification and load unsigned software on an affected device. To exploit this vulnerability, the attacker must have root-system privileges on the affected device.
This vulnerability is due to incomplete validation of files during the installation of an .iso file. An attacker could exploit this vulnerability by modifying contents of the .iso image and then installing and activating it on the device. A successful exploit could allow the attacker to load an unsigned file as part of the image activation process. |
| A vulnerability in the CLI of Cisco Secure Firewall Management Center (FMC) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow an authenticated, local attacker to execute arbitrary commands on the underlying operating system as root.
This vulnerability is due to improper input validation for specific CLI commands. An attacker could exploit this vulnerability by injecting operating system commands into a legitimate command. A successful exploit could allow the attacker to escape the restricted command prompt and execute arbitrary commands on the underlying operating system. To successfully exploit this vulnerability, an attacker would need valid Administrator credentials.
For more information about vulnerable scenarios, see the Details ["#details"] section of this advisory. |
| A vulnerability in the Cisco Industrial Ethernet Switch Device Manager (DM) of Cisco IOS Software could allow an authenticated, remote attacker to elevate privileges.
This vulnerability is due to insufficient validation of authorizations for authenticated users. An attacker could exploit this vulnerability by sending a crafted HTTP request to an affected device. A successful exploit could allow the attacker to elevate privileges to privilege level 15.
To exploit this vulnerability, the attacker must have valid credentials for a user account with privilege level 5 or higher. Read-only DM users are assigned privilege level 5. |
