| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
lib/generic-radix-tree.c: Fix rare race in __genradix_ptr_alloc()
If we need to increase the tree depth, allocate a new node, and then
race with another thread that increased the tree depth before us, we'll
still have a preallocated node that might be used later.
If we then use that node for a new non-root node, it'll still have a
pointer to the old root instead of being zeroed - fix this by zeroing it
in the cmpxchg failure path. |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: keystone: Add workaround for Errata #i2037 (AM65x SR 1.0)
Errata #i2037 in AM65x/DRA80xM Processors Silicon Revision 1.0
(SPRZ452D_July 2018_Revised December 2019 [1]) mentions when an
inbound PCIe TLP spans more than two internal AXI 128-byte bursts,
the bus may corrupt the packet payload and the corrupt data may
cause associated applications or the processor to hang.
The workaround for Errata #i2037 is to limit the maximum read
request size and maximum payload size to 128 bytes. Add workaround
for Errata #i2037 here.
The errata and workaround is applicable only to AM65x SR 1.0 and
later versions of the silicon will have this fixed.
[1] -> https://www.ti.com/lit/er/sprz452i/sprz452i.pdf |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: pm80xx: Set phy->enable_completion only when we wait for it
pm8001_phy_control() populates the enable_completion pointer with a stack
address, sends a PHY_LINK_RESET / PHY_HARD_RESET, waits 300 ms, and
returns. The problem arises when a phy control response comes late. After
300 ms the pm8001_phy_control() function returns and the passed
enable_completion stack address is no longer valid. Late phy control
response invokes complete() on a dangling enable_completion pointer which
leads to a kernel crash. |
| In the Linux kernel, the following vulnerability has been resolved:
fsnotify: clear PARENT_WATCHED flags lazily
In some setups directories can have many (usually negative) dentries.
Hence __fsnotify_update_child_dentry_flags() function can take a
significant amount of time. Since the bulk of this function happens
under inode->i_lock this causes a significant contention on the lock
when we remove the watch from the directory as the
__fsnotify_update_child_dentry_flags() call from fsnotify_recalc_mask()
races with __fsnotify_update_child_dentry_flags() calls from
__fsnotify_parent() happening on children. This can lead upto softlockup
reports reported by users.
Fix the problem by calling fsnotify_update_children_dentry_flags() to
set PARENT_WATCHED flags only when parent starts watching children.
When parent stops watching children, clear false positive PARENT_WATCHED
flags lazily in __fsnotify_parent() for each accessed child. |
| In the Linux kernel, the following vulnerability has been resolved:
smack: tcp: ipv4, fix incorrect labeling
Currently, Smack mirrors the label of incoming tcp/ipv4 connections:
when a label 'foo' connects to a label 'bar' with tcp/ipv4,
'foo' always gets 'foo' in returned ipv4 packets. So,
1) returned packets are incorrectly labeled ('foo' instead of 'bar')
2) 'bar' can write to 'foo' without being authorized to write.
Here is a scenario how to see this:
* Take two machines, let's call them C and S,
with active Smack in the default state
(no settings, no rules, no labeled hosts, only builtin labels)
* At S, add Smack rule 'foo bar w'
(labels 'foo' and 'bar' are instantiated at S at this moment)
* At S, at label 'bar', launch a program
that listens for incoming tcp/ipv4 connections
* From C, at label 'foo', connect to the listener at S.
(label 'foo' is instantiated at C at this moment)
Connection succeedes and works.
* Send some data in both directions.
* Collect network traffic of this connection.
All packets in both directions are labeled with the CIPSO
of the label 'foo'. Hence, label 'bar' writes to 'foo' without
being authorized, and even without ever being known at C.
If anybody cares: exactly the same happens with DCCP.
This behavior 1st manifested in release 2.6.29.4 (see Fixes below)
and it looks unintentional. At least, no explanation was provided.
I changed returned packes label into the 'bar',
to bring it into line with the Smack documentation claims. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: stm32/cryp - call finalize with bh disabled
The finalize operation in interrupt mode produce a produces a spinlock
recursion warning. The reason is the fact that BH must be disabled
during this process. |
| In the Linux kernel, the following vulnerability has been resolved:
dma-debug: fix a possible deadlock on radix_lock
radix_lock() shouldn't be held while holding dma_hash_entry[idx].lock
otherwise, there's a possible deadlock scenario when
dma debug API is called holding rq_lock():
CPU0 CPU1 CPU2
dma_free_attrs()
check_unmap() add_dma_entry() __schedule() //out
(A) rq_lock()
get_hash_bucket()
(A) dma_entry_hash
check_sync()
(A) radix_lock() (W) dma_entry_hash
dma_entry_free()
(W) radix_lock()
// CPU2's one
(W) rq_lock()
CPU1 situation can happen when it extending radix tree and
it tries to wake up kswapd via wake_all_kswapd().
CPU2 situation can happen while perf_event_task_sched_out()
(i.e. dma sync operation is called while deleting perf_event using
etm and etr tmc which are Arm Coresight hwtracing driver backends).
To remove this possible situation, call dma_entry_free() after
put_hash_bucket() in check_unmap(). |
| In the Linux kernel, the following vulnerability has been resolved:
pinmux: Use sequential access to access desc->pinmux data
When two client of the same gpio call pinctrl_select_state() for the
same functionality, we are seeing NULL pointer issue while accessing
desc->mux_owner.
Let's say two processes A, B executing in pin_request() for the same pin
and process A updates the desc->mux_usecount but not yet updated the
desc->mux_owner while process B see the desc->mux_usecount which got
updated by A path and further executes strcmp and while accessing
desc->mux_owner it crashes with NULL pointer.
Serialize the access to mux related setting with a mutex lock.
cpu0 (process A) cpu1(process B)
pinctrl_select_state() { pinctrl_select_state() {
pin_request() { pin_request() {
...
....
} else {
desc->mux_usecount++;
desc->mux_usecount && strcmp(desc->mux_owner, owner)) {
if (desc->mux_usecount > 1)
return 0;
desc->mux_owner = owner;
} } |
| In the Linux kernel, the following vulnerability has been resolved:
um: line: always fill *error_out in setup_one_line()
The pointer isn't initialized by callers, but I have
encountered cases where it's still printed; initialize
it in all possible cases in setup_one_line(). |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info
The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the
routine unconditionally frees submitted mailbox commands regardless of
return status. The issue is that for MBX_TIMEOUT cases, when firmware
returns SFP information at a later time, that same mailbox memory region
references previously freed memory in its cmpl routine.
Fix by adding checks for the MBX_TIMEOUT return code. During mailbox
resource cleanup, check the mbox flag to make sure that the wait did not
timeout. If the MBOX_WAKE flag is not set, then do not free the resources
because it will be freed when firmware completes the mailbox at a later
time in its cmpl routine.
Also, increase the timeout from 30 to 60 seconds to accommodate boot
scripts requiring longer timeouts. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: don't BUG_ON on ENOMEM from btrfs_lookup_extent_info() in walk_down_proc()
We handle errors here properly, ENOMEM isn't fatal, return the error. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: clean up our handling of refs == 0 in snapshot delete
In reada we BUG_ON(refs == 0), which could be unkind since we aren't
holding a lock on the extent leaf and thus could get a transient
incorrect answer. In walk_down_proc we also BUG_ON(refs == 0), which
could happen if we have extent tree corruption. Change that to return
-EUCLEAN. In do_walk_down() we catch this case and handle it correctly,
however we return -EIO, which -EUCLEAN is a more appropriate error code.
Finally in walk_up_proc we have the same BUG_ON(refs == 0), so convert
that to proper error handling. Also adjust the error message so we can
actually do something with the information. |
| In the Linux kernel, the following vulnerability has been resolved:
ethtool: fail closed if we can't get max channel used in indirection tables
Commit 0d1b7d6c9274 ("bnxt: fix crashes when reducing ring count with
active RSS contexts") proves that allowing indirection table to contain
channels with out of bounds IDs may lead to crashes. Currently the
max channel check in the core gets skipped if driver can't fetch
the indirection table or when we can't allocate memory.
Both of those conditions should be extremely rare but if they do
happen we should try to be safe and fail the channel change. |
| In the Linux kernel, the following vulnerability has been resolved:
MIPS: cevt-r4k: Don't call get_c0_compare_int if timer irq is installed
This avoids warning:
[ 0.118053] BUG: sleeping function called from invalid context at kernel/locking/mutex.c:283
Caused by get_c0_compare_int on secondary CPU.
We also skipped saving IRQ number to struct clock_event_device *cd as
it's never used by clockevent core, as per comments it's only meant
for "non CPU local devices". |
| In the Linux kernel, the following vulnerability has been resolved:
ELF: fix kernel.randomize_va_space double read
ELF loader uses "randomize_va_space" twice. It is sysctl and can change
at any moment, so 2 loads could see 2 different values in theory with
unpredictable consequences.
Issue exactly one load for consistent value across one exec. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: use IWL_FW_CHECK for link ID check
The lookup function iwl_mvm_rcu_fw_link_id_to_link_conf() is
normally called with input from the firmware, so it should use
IWL_FW_CHECK() instead of WARN_ON(). |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: Fix negative array index read
Avoid using the negative values
for clk_idex as an index into an array pptable->DpmDescriptor.
V2: fix clk_index return check (Tim Huang) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/bridge: tc358767: Check if fully initialized before signalling HPD event via IRQ
Make sure the connector is fully initialized before signalling any
HPD events via drm_kms_helper_hotplug_event(), otherwise this may
lead to NULL pointer dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
udf: Avoid excessive partition lengths
Avoid mounting filesystems where the partition would overflow the
32-bits used for block number. Also refuse to mount filesystems where
the partition length is so large we cannot safely index bits in a
block bitmap. |
| In the Linux kernel, the following vulnerability has been resolved:
powerpc/rtas: Prevent Spectre v1 gadget construction in sys_rtas()
Smatch warns:
arch/powerpc/kernel/rtas.c:1932 __do_sys_rtas() warn: potential
spectre issue 'args.args' [r] (local cap)
The 'nargs' and 'nret' locals come directly from a user-supplied
buffer and are used as indexes into a small stack-based array and as
inputs to copy_to_user() after they are subject to bounds checks.
Use array_index_nospec() after the bounds checks to clamp these values
for speculative execution. |
