| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| `gx_binres_theme_load()` sizes its theme buffer for the theme it was asked for, and allocates it even when the resource holds no theme with that id. A theme id at or past the theme count declared by the resource gets a buffer of zero bytes. The load pass then walks past the end of the theme table, takes whatever follows as a theme header, and writes a `GX_THEME` and its tables into that zero-byte buffer. |
| Mounting an attacker-controlled NAND flash image (`lx_nand_flash_open()`) triggers an unbounded out-of-bounds heap **write** in LevelX's NAND flash-translation-layer metadata parser that overwrites a driver function pointer in the control block, giving a demonstrated control-flow hijack — RIP set to a full 8-byte attacker-chosen value (register-verified). Two accompanying OOB reads. All reproduced verbatim under ASan at HEAD `9f1cfdc`. (The affected metadata-parser header states "Some portions generated by Copilot (Sonnet 4.6)" — an AI-generated parser with an unchecked on-flash count.) |
| Buffer overflow vulnerability exists in the affected interface of HPE Networking Instant ON that could allow an unauthenticated remote attacker to run arbitrary code on the underlying host. Successful exploitation could allow an attacker to execute arbitrary code as a privileged user on the underlying operating system. |
| Uncontrolled Format string vulnerabilities exist in the affected interface of HPE Networking Instant ON APs that could allow an unauthenticated remote attacker to run arbitrary commands on the underlying host. Successful exploitation could result in a Denial-of-service or potential remote code execution. |
| Buffer overflow vulnerabilities exist in the affected interface of HPE Networking Instant ON APS that could allow an unauthenticated adjacent attacker to achieve remote code execution. Successful exploitation could allow an attacker to execute arbitrary commands on the underlying operating system. |
| A command injection vulnerability exists in CLI of the affected HPE Networking Instant ON APs that could allow an unauthenticated adjacent attacker to perform command injection by sending specially crafted packets. Successful exploitation could allow an attacker to execute arbitrary commands as a privileged user on the underlying operating system. |
| A vulnerability has been identified in a management protocol of HPE Networking Instant ON APs that could allow an unauthenticated adjacent attacker to circumvent existing authentication controls. Successful exploitation could result in a complete bypass of security restrictions, potentially leading to remote code execution with elevated privileges. |
| An authentication bypass vulnerability in the API endpoint of HPE Networking Instant ON could allow an unauthenticated remote attacker to bypass network access controls if certain preconditions outside of the attacker's control are met. Successful exploitation could allow an attacker to obtain unauthorized access to restricted networks. |
| Command injection vulnerabilities exist in the affected interface of HPE Networking Instant ON that could allow an authenticated remote attacker with high privileges to perform command injection. Successful exploitation could allow an attacker to execute arbitrary commands as a privileged user on the underlying operating system. |
| A vulnerability in the API endpoint of HPE Networking Instant ON APs could allow an authenticated remote attacker with high privileges to conduct a server-side request forgery (SSRF) attack. Successful exploitation could allow an attacker to execute arbitrary commands as a privileged user on the underlying operating system. |
| A format string vulnerability in the API endpoint of HPE Networking Instant ON APs could allow an authenticated remote attacker with high privileges to cause memory corruption with a modified input. Successful exploitation could allow an attacker to provoke a denial-of-service condition or remote code execution in the affected system function. |
| Incorrect authorization in SiteIsolation in Google Chrome prior to 154.0.8037.92 allowed a remote attacker who had compromised the renderer process to bypass web origin policy via a crafted HTML page. (Chromium security severity: Low) |
| A vulnerability was determined in Freedesktop Poppler 26.06.0/26.07.0/26.08.0. This impacts the function FoFiTrueType::cvtSfnts of the file fofi/FoFiTrueType.cc. This manipulation causes integer overflow. The attack can only be executed locally. The exploit has been publicly disclosed and may be utilized. Patch name: 245d3c6823377755f2c1d5fdddd010279c6ed94d. It is suggested to install a patch to address this issue. |
| An attacker can construct a request that, if issued by another application user, will cause JavaScript code supplied by the attacker to execute within the user's browser in the context of that user's session with the application. |
| In the Linux kernel, the following vulnerability has been resolved:
net/mlx5e: Fix use-after-free race in sample_restore_put()
Concurrent teardown of TC sample rules sharing the same restore
context may re-read restore->count after dropping restore_lock.
At that point another thread may already have completed cleanup and
freed the restore object.
Use the result of the refcount decrement while holding restore_lock to
determine whether cleanup is needed. |
| In the Linux kernel, the following vulnerability has been resolved:
eth: nfp: bound the ntuple rule dump by the caller's buffer size
nfp_net_get_fs_loc() dumps every entry of nn->fs.list into rule_locs[]
without consulting cmd->rule_cnt, which is how many entries the caller
had room for. ETHTOOL_GRXCLSRLALL requires no CAP_NET_ADMIN and the
ioctl sizes the buffer from the rule_cnt userspace passes in, so once an
admin has installed flow steering rules any user can ask for fewer slots
than there are rules and run off the end of the allocation. A rule_cnt
of 0 leaves the buffer pointer NULL and the walk dereferences it.
Bail out with -EMSGSIZE when the buffer fills up, the way the other
ntuple capable drivers do, and report how many locations were filled so
a shrinking rule list does not leave the caller reading stale slots. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject untrusted allocated-object pointers
When the final RCU read-side critical section ends, a local kptr is demoted
to PTR_UNTRUSTED but retains MEM_ALLOC. The pointer may be NULL or may refer
to an object whose lifetime is no longer protected.
type_is_ptr_alloc_obj() nevertheless recognizes any PTR_TO_BTF_ID with
MEM_ALLOC as a live allocated object. In particular, a refcount-only local
kptr never carries NON_OWN_REF, so it still passes the
bpf_refcount_acquire() argument check after RCU protection ends. The kfunc
can then dereference NULL or stale memory.
Make type_is_ptr_alloc_obj() reject PTR_UNTRUSTED pointers. Since
type_is_non_owning_ref() is based on the same predicate, graph kfunc
arguments obey the same live-object requirement. Fault-protected reads of
the demoted pointer remain valid: writes are already rejected, and read
fixups use bpf_may_fault_on_deref() rather than this predicate.
[ kkd: Rewrote commit log ] |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Require MEM_PERCPU for percpu kptr stores
map_kptr_match_type() treats perm_flags as the set of register type flags
that a kptr field permits. Adding MEM_PERCPU to that set for
BPF_KPTR_PERCPU does not require the source register to carry it, however.
The subset test consequently accepts both a plain bpf_obj_new() allocation
and a referenced kernel pointer into a __percpu_kptr map field.
Loads from the field are always marked MEM_PERCPU. Consumers then treat the
stored value as the cookie returned by bpf_percpu_obj_new(): per-CPU pointer
helpers relocate it, and map teardown selects the per-CPU free path. A plain
allocation can therefore provide an arbitrary kernel read/write, while a
kernel pointer can be relocated into an invalid address or sent through a
missing destructor.
Require the source MEM_PERCPU flag to match the destination field kind.
This preserves valid bpf_percpu_obj_new() stores and rejects both the
program-BTF and kernel-BTF variants. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Mark the zero register precise for a register-form NULL check
check_cond_jmp_op() accepts "if rA <op> rB" as a NULL check for a
nullable pointer rA when rB is a scalar known to be zero,
lifts PTR_MAYBE_NULL from rA in the corresponding branch and does not
mark rB precise. Consider the following program:
r0 = bpf_get_prandom_u32();
r6 = 1; /* the r6 == 0 path is explored first */
if (r0 == 0) goto 1f;
r6 = 0;
1:
r0 = bpf_map_lookup_elem(map, &0); /* absent, NULL at runtime */
if (r0 == r6) goto 2f; /* taken as a NULL check for r0 */
*(u8 *)(r0 + 0); /* verifier: map value; runtime: zero */
2:
return 0;
The r6 == 0 path is explored first and the dereference is accepted.
The r6 == 1 path is pruned at the checkpoint recorded for (1),
so the comparison is never verified with a non-zero r6. At runtime a
failed lookup returns NULL, NULL != 1 takes the non-NULL edge and the
program dereferences a pointer that is zero. |
| An authentication bypass vulnerability exists in the PAPI protocol of HPE Networking Instant ON APs that could allow an unauthenticated adjacent attacker to circumvent existing authentication controls. Successful exploitation could allow an attacker to circumvent certain existing authentication mechanisms and send unauthorized network traffic to the target device. |
