| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/mana_ib: Disable RX steering on RSS QP destroy
When an RSS QP is destroyed (e.g. DPDK exit), mana_ib_destroy_qp_rss()
destroys the RX WQ objects but does not disable vPort RX steering in
firmware. This leaves stale steering configuration that still points to
the destroyed RX objects.
If traffic continues to arrive (e.g. peer VM is still transmitting) and
the VF interface is subsequently brought up (mana_open), the firmware
may deliver completions using stale CQ IDs from the old RX objects.
These CQ IDs can be reused by the ethernet driver for new TX CQs,
causing RX completions to land on TX CQs:
WARNING: mana_poll_tx_cq+0x1b8/0x220 [mana] (is_sq == false)
WARNING: mana_gd_process_eq_events+0x209/0x290 (cq_table lookup fails)
Fix this by disabling vPort RX steering before destroying RX WQ objects.
Note that mana_fence_rqs() cannot be used here because the fence
completion is delivered on the CQ, which is polled by user-mode (e.g.
DPDK) and not visible to the kernel driver.
Refactor the disable logic into a shared mana_disable_vport_rx() in
mana_en, exported for use by mana_ib, replacing the duplicate code.
The ethernet driver's mana_dealloc_queues() is also updated to call
this common function. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: fix a resource leak in xfs_alloc_buftarg()
In the error path, call fs_put_dax() to drop the DAX
device reference. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (powerz) Avoid cacheline sharing for DMA buffer
Depending on the architecture the transfer buffer may share a cacheline
with the following mutex. As the buffer may be used for DMA, that is
problematic.
Use the high-level DMA helpers to make sure that cacheline sharing can
not happen.
Also drop the comment, as the helpers are documentation enough.
https://sashiko.dev/#/message/20260408175814.934BFC19421%40smtp.kernel.org |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: endpoint: pci-epf-ntb: Remove duplicate resource teardown
epf_ntb_epc_destroy() duplicates the teardown that the caller is
supposed to do later. This leads to an oops when .allow_link fails or
when .drop_link is performed. Remove the helper.
Also drop pci_epc_put(). EPC device refcounting is tied to configfs EPC
group lifetime, and pci_epc_put() in the .drop_link path is sufficient. |
| Microsoft UFO open-source framework for intelligent automation across devices and platforms. In 3.0.1-4-ge2626659, Microsoft UFO's WebSocket control plane trusts client-supplied identity and role fields in task messages. A client connection can register as a normal device, but later send a TASK message claiming client_type="constellation" and target_id=<victim-device-id>. The server trusts the role and target values from the wire message rather than enforcing the role registered for that WebSocket connection. As a result, any authenticated WebSocket client with the shared server token can spoof the higher-privilege constellation role and dispatch attacker-controlled tasks to another connected device. The same client registry also allows duplicate client_id registration, overwriting an existing live client's stored websocket, role, and task protocol. This is an authenticated WebSocket role/identity spoofing issue leading to peer task hijacking. |
| Microsoft UFO open-source framework for intelligent automation across devices and platforms. In 3.0.1-4-ge2626659, Microsoft UFO uses the user-controlled task_name value directly when constructing session log paths. An authenticated client can supply path traversal sequences in task_name and cause UFO to create log directories and log files outside the intended logs/ directory. |
| Buffer copy without checking size of input ('Classic Buffer Overflow') vulnerability in AdminCenter in Synology BeeStation OS before 1.3.2-65648 allows remote attackers to execute arbitrary code via unspecified vectors. |
| In the Linux kernel, the following vulnerability has been resolved:
accel/amdxdna: Hold mm structure across iommu_sva_unbind_device()
Some tests trigger a crash in iommu_sva_unbind_device() due to
accessing iommu_mm after the associated mm structure has been
freed.
Fix this by taking an explicit reference to the mm structure
after successfully binding the device, and releasing it only
after the device is unbound. This ensures the mm remains valid
for the entire SVA bind/unbind lifetime. |
| In the Linux kernel, the following vulnerability has been resolved:
ublk: Validate SQE128 flag before accessing the cmd
ublk_ctrl_cmd_dump() accesses (header *)sqe->cmd before
IO_URING_F_SQE128 flag check. This could cause out of boundary memory
access.
Move the SQE128 flag check earlier in ublk_ctrl_uring_cmd() to return
-EINVAL immediately if the flag is not set. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon/core: validate damos_quota_goal->nid for node_mem_{used,free}_bp
Patch series "mm/damon/core: validate damos_quota_goal->nid".
node_mem[cg]_{used,free}_bp DAMOS quota goals receive the node id. The
node id is used for si_meminfo_node() and NODE_DATA() without proper
validation. As a result, privileged users can trigger an out of bounds
memory access using DAMON_SYSFS. Fix the issues.
The issue was originally reported [1] with a fix by another author. The
original author announced [2] that they will stop working including the
fix that was still in the review stage. Hence I'm restarting this.
This patch (of 2):
Users can set damos_quota_goal->nid with arbitrary value for
node_mem_{used,free}_bp. But DAMON core is using those for
si_meminfo_node() without the validation of the value. This can result in
out of bounds memory access. The issue can actually triggered using DAMON
user-space tool (damo), like below.
$ sudo ./damo start --damos_action stat \
--damos_quota_goal node_mem_used_bp 50% -1 \
--damos_quota_interval 1s
$ sudo dmesg
[...]
[ 65.565986] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000098
Fix this issue by adding the validation of the given node. If an invalid
node id is given, it returns 0% for used memory ratio, and 100% for free
memory ratio. |
| In the Linux kernel, the following vulnerability has been resolved:
hfsplus: return error when node already exists in hfs_bnode_create
When hfs_bnode_create() finds that a node is already hashed (which should
not happen in normal operation), it currently returns the existing node
without incrementing its reference count. This causes a reference count
inconsistency that leads to a kernel panic when the node is later freed
in hfs_bnode_put():
kernel BUG at fs/hfsplus/bnode.c:676!
BUG_ON(!atomic_read(&node->refcnt))
This scenario can occur when hfs_bmap_alloc() attempts to allocate a node
that is already in use (e.g., when node 0's bitmap bit is incorrectly
unset), or due to filesystem corruption.
Returning an existing node from a create path is not normal operation.
Fix this by returning ERR_PTR(-EEXIST) instead of the node when it's
already hashed. This properly signals the error condition to callers,
which already check for IS_ERR() return values. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: imx: fix use-after-free on unbind
The SPI subsystem frees the controller and any subsystem allocated
driver data as part of deregistration (unless the allocation is device
managed).
Take another reference before deregistering the controller so that the
driver data is not freed until the driver is done with it. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: sd: fix missing put_disk() when device_add(&disk_dev) fails
If device_add(&sdkp->disk_dev) fails, put_device() runs
scsi_disk_release(), which frees the scsi_disk but leaves the gendisk
referenced. The device_add_disk() error path in sd_probe() calls
put_disk(gd); call put_disk(gd) here to mirror that cleanup. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pt5161l) Fix bugs in pt5161l_read_block_data()
Fix two bugs in pt5161l_read_block_data():
1. Buffer overrun: The local buffer rbuf is declared as u8 rbuf[24],
but i2c_smbus_read_block_data() can return up to
I2C_SMBUS_BLOCK_MAX (32) bytes. The i2c-core copies the data into
the caller's buffer before the return value can be checked, so
the post-read length validation does not prevent a stack overrun
if a device returns more than 24 bytes. Resize the buffer to
I2C_SMBUS_BLOCK_MAX.
2. Unexpected positive return on length mismatch: When all three
retries are exhausted because the device returns data with an
unexpected length, i2c_smbus_read_block_data() returns a positive
byte count. The function returns this directly, and callers treat
any non-negative return as success, processing stale or incomplete
buffer contents. Return -EIO when retries are exhausted with a
positive return value, preserving the negative error code on I2C
failure. |
| In the Linux kernel, the following vulnerability has been resolved:
zram: do not forget to endio for partial discard requests
As reported by Qu Wenruo and Avinesh Kumar, the following
getconf PAGESIZE
65536
blkdiscard -p 4k /dev/zram0
takes literally forever to complete. zram doesn't support partial
discards and just returns immediately w/o doing any discard work in such
cases. The problem is that we forget to endio on our way out, so
blkdiscard sleeps forever in submit_bio_wait(). Fix this by jumping to
end_bio label, which does bio_endio(). |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix bounds check in check_xattrs() to prevent out-of-bounds access
The bounds check for the next xattr entry in check_xattrs() uses
(void *)next >= end, which allows next to point within sizeof(u32)
bytes of end. On the next loop iteration, IS_LAST_ENTRY() reads 4
bytes via *(__u32 *)(entry), which can overrun the valid xattr region.
For example, if next lands at end - 1, the check passes since
next < end, but IS_LAST_ENTRY() reads 4 bytes starting at end - 1,
accessing 3 bytes beyond the valid region.
Fix this by changing the check to (void *)next + sizeof(u32) > end,
ensuring there is always enough space for the IS_LAST_ENTRY() read
on the subsequent iteration. |
| Jenkins LDAP Plugin 807.v7d7de30930cf and earlier deserializes data from LDAP referrals without validation. |
| Jenkins Job Import Plugin 143.v044a_2e819b_27 and earlier does not perform a permission check in an HTTP endpoint, allowing attackers with Overall/Read permission to enumerate credentials IDs of credentials stored in Jenkins. |
| In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: auth_gss: fix memory leaks in XDR decoding error paths
The gssx_dec_ctx(), gssx_dec_status(), and gssx_dec_name()
functions allocate memory via gssx_dec_buffer(), which calls
kmemdup(). When a subsequent decode operation fails, these
functions return immediately without freeing previously
allocated buffers, causing memory leaks.
The leak in gssx_dec_ctx() is particularly relevant because
the caller (gssp_accept_sec_context_upcall) initializes several
buffer length fields to non-zero values, resulting in memory
allocation:
struct gssx_ctx rctxh = {
.exported_context_token.len = GSSX_max_output_handle_sz,
.mech.len = GSS_OID_MAX_LEN,
.src_name.display_name.len = GSSX_max_princ_sz,
.targ_name.display_name.len = GSSX_max_princ_sz
};
If, for example, gssx_dec_name() succeeds for src_name but
fails for targ_name, the memory allocated for
exported_context_token, mech, and src_name.display_name
remains unreferenced and cannot be reclaimed.
Add error handling with goto-based cleanup to free any
previously allocated buffers before returning an error. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: ccree - fix a memory leak in cc_mac_digest()
Add cc_unmap_result() if cc_map_hash_request_final()
fails to prevent potential memory leak. |
