| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Russh is a Rust SSH client and server library. Prior to 0.63.1, a connection configured to permit mac=none can negotiate it with a MAC-requiring CTR or CBC block cipher because the selection logic validates needs_mac() only when MAC selection fails. A remote peer can then send a packet with a decrypted length of zero, causing russh/src/cipher/mod.rs to shrink the previously read block before indexing buffer.buffer[16..], which panics and terminates the connection task. This issue is fixed in version 0.63.1. |
| Issue summary: An established DTLS 1.2 association using an AEAD cipher suite
can be terminated by a single unauthenticated datagram whose encrypted
fragment is shorter than the mandatory explicit IV and authentication tag
overhead.
Impact summary: An attacker who can send a datagram that is routed to an
existing DTLS 1.2 association can tear that association down without knowing
any key material. This is a Denial of Service limited to the targeted
association. There is no memory safety or confidentiality impact.
CWE: CWE-1284: Improper Validation of Specified Quantity in Input
Description: In TLS 1.2 and DTLS 1.2 every record protected by an AEAD cipher
suite carries an explicit IV followed by the ciphertext and an authentication
tag. When decrypting such a record the record layer passed the record length to
the cipher implementation before checking that the record was long enough to
contain the explicit IV and the tag. For a record shorter than that overhead the
cipher implementation rejected the impossible length, and the record layer
treated this as an internal failure and raised a fatal internal_error alert
instead of treating the record as one that failed authentication.
In TLS 1.2 the same record causes a fatal internal_error alert instead of the
expected bad_record_mac alert. Since any undecryptable record already
terminates a TLS connection, this is a protocol conformance issue rather than
a security issue in TLS.
The fix validates the record length against the explicit IV and tag length
before any AEAD processing, so that TLS reports bad_record_mac and DTLS
silently discards the record.
FIPS impact: no
The affected code is outside the FIPS module boundary. |
| In the Linux kernel, the following vulnerability has been resolved:
smb/client: validate new EOF for insert range
smb3_insert_range() does not check if the new file size
(i_size + len) is valid. This allows FALLOC_FL_INSERT_RANGE to bypass
RLIMIT_FSIZE, exceed s_maxbytes, or produce a size outside the loff_t
range.
Use check_add_overflow() to calculate the new EOF. Validate it with
inode_newsize_ok() before modifying the file.
Reproducer, using a file on a CIFS mount:
bash -c '
FILE=/mnt/cifs/repro
trap "" SIGXFSZ
ulimit -f 3072 # RLIMIT_FSIZE = 3 MiB
# A regular write is stopped at 3 MiB.
dd if=/dev/zero of="$FILE" bs=1M count=4 status=none
stat -c "size after write: %s" "$FILE"
# Insert 2 MiB into a 2 MiB file.
truncate -s 2M "$FILE"
fallocate -i -o 0 -l 2M "$FILE"
stat -c "size after insert: %s" "$FILE"
'
Before this change, the regular write stops at the 3 MiB limit, but
insert range grows the file to 4 MiB:
dd: error writing '/mnt/cifs/repro': File too large
size after write: 3145728
size after insert: 4194304
After this change, insert range also fails at the limit and leaves the
2 MiB file unchanged:
dd: error writing '/mnt/cifs/repro': File too large
size after write: 3145728
fallocate: fallocate failed: File too large
size after insert: 2097152 |
| In the Linux kernel, the following vulnerability has been resolved:
net: bcmasp: fix tx_spb_ring_full() checking same slot cnt times
The loop initialised next_index from intf->tx_spb_index on every
iteration, so incr_ring() always produced the same result and only
one slot was ever tested. Move the initialisation before the loop
so each iteration advances next_index and the function correctly
checks that cnt consecutive descriptor slots are available before
allowing a new transmission. |
| Heap-based buffer overflow in Microsoft Office Word allows an unauthorized attacker to execute code over a network. |
| A flaw was found in libsoup. When the permessage-deflate WebSocket extension compresses a very large outgoing message, truncated size calculations used for GByteArray growth could wrap, causing zlib to write past the allocated buffer and resulting in a heap buffer overflow. |
| ZoneMinder before 1.38.4 contains static buffer overflow vulnerabilities in RemoteCameraHttp::GetResponse() that allow malicious HTTP cameras or intercepting attackers to overflow fixed-size buffers by sending oversized response headers. Attackers can send crafted HTTP responses with oversized status messages, Connection headers, Content-Type values, or multipart boundaries to corrupt parser state and crash the capture process or corrupt memory. |
| In the Linux kernel, the following vulnerability has been resolved:
net: reject oversized tx_queue_len at netlink parse time
rtnl_create_link() assigns IFLA_TXQLEN directly to dev->tx_queue_len
without going through netif_change_tx_queue_len(), so a device created
with "ip link add ... txqueuelen 500000" bypasses the S16_MAX cap and
still triggers the oversized ring allocations in pfifo_fast, tun and
tap. The veth peer nest (rtnl_nla_parse_ifinfomsg()) and the
RTM_NEWLINK-on-existing-device path reach the same sinks.
Enforce the cap in ifla_policy instead: IFLA_TXQLEN becomes
NLA_POLICY_FULL_RANGE(NLA_U32, &txqlen_range) with
txqlen_range = { .min = 0, .max = S16_MAX }. All netlink consumers
parse against this policy - rtnl_setlink(), rtnl_newlink() (create
and change), and the veth peer nest - so every netlink path is capped
at parse time and rejects the attribute with -ERANGE plus a proper
"integer out of range" extack message before any device state is
modified (the RTM_SETLINK half-application wart is gone with it).
Document the bound in the rt-link.yaml netlink spec.
Conditions to recreate the bug:
- CONFIG_NET_SCHED=y, CONFIG_VETH=y, CONFIG_USER_NS=y, CONFIG_NET_NS=y.
- Unprivileged user in a fresh user+net namespace (unshare -Urn):
ip link add v0 txqueuelen 500000 type veth peer name v1
-> on the fixed kernel this is rejected with -ERANGE ("integer out
of range" extack) instead of installing an oversized tx_queue_len
that later inflates pfifo_fast/tun/tap ring allocations.
- ip link set v0 txqueuelen 500000 is likewise rejected at parse time. |
| Heap-based buffer overflow in Active Directory Domain Services allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
perf: RISC-V: store available counter mask as bitmap
The available-counter mask was a single unsigned long, but iteration
uses RISCV_MAX_COUNTERS, which is 64. On RV32 that reads past the object.
Filling with an unsigned-long bit at index 32 and above is also wrong.
Use DECLARE_BITMAP and set_bit/bitmap helpers. Walk each bitmap word
into CFG_MATCH when checking events, when allocating an index, and when
stopping all counters. Set the counter base to i times BITS_PER_LONG.
Share the CFG_MATCH ecall through a small helper so the 32-bit argument
split is not duplicated. On qemu-system-riscv32 the probe bitmap has bits
above XLEN set, so the first word alone is not enough.
[pjw@kernel.org: updated to apply; fixed checkpatch.pl issues] |
| Out-of-bounds read in Microsoft Standard XPS allows an authorized attacker to disclose information locally. |
| Out-of-bounds read in Microsoft Standard XPS allows an authorized attacker to disclose information locally. |
| A stack-based buffer overflow flaw was found in fetchmail when built with NTLM support. A malicious or compromised mail server advertising NTLM authentication can send a crafted Type 2 challenge that causes fetchmail to write past a fixed stack buffer while building the NTLM authenticate response. This may lead to remote code execution depending on stack-frame layout, or to authentication failure or process termination under memory hardening. |
| A flaw was found in libsoup. The soup_uri_decode_data_uri() function incorrectly treated base64 data-URI payloads as NUL-terminated strings when calling g_base64_decode_inplace(). If the percent-decoded payload contained embedded NUL bytes, the decoded length could remain uninitialized and be used as the size of the returned GBytes. This can lead to an out-of-bounds read or application crash when processing a crafted data URI. |
| FreeRDP is a free implementation of the Remote Desktop Protocol. Prior to 3.27.0, FreeRDP clients using TS Gateway accept a server-controlled max_xmit_frag value in libfreerdp/core/gateway/rpc_bind.c without bounding it to the 4088-byte ReceiveFragment allocation. A malicious gateway can advertise 65535 and then send a response fragment of the same length, causing rpc_channel_read in libfreerdp/core/gateway/rpc.c to write up to 65535 bytes into the smaller ReceiveFragment buffer. This can crash the client and may permit code execution through attacker-controlled heap corruption. This issue is fixed in version 3.27.0. |
| OpenImageIO is a toolset for reading, writing, and manipulating image files of any image file format relevant to VFX / animation. Prior to versions 3.0.16.0 and 3.1.11.0, processing a crafted BMP file through oiiotool or an application linked to OpenImageIO can reach BMP palette handling in src/bmp.imageio/bmpinput.cpp with an empty color table. BmpInput::read_native_scanline then performs an invalid palette read while decoding an RLE-compressed scanline, causing a process crash and denial of service. This issue is fixed in versions 3.0.16.0 and 3.1.11.0. |
| OpenImageIO is a toolset for reading, writing, and manipulating image files of any image file format relevant to VFX / animation. Prior to 3.0.20.0, 3.1.15.0, and 3.2.0.3-beta1, A crafted cineon file can supply a numberofelements value greater than the format maximum of eight. cineoninput::open() uses that unchecked value as the loop bound while filling the fixed strings[8] array, writing pointers beyond the stack buffer and into adjacent state, resulting in memory corruption and denial of service. The affected implementation is identified by src/cineon.imageio/cineoninput.cpp, CineonInput::open(), numberOfElements, and strings[8], which define the relevant source path, functions, state, and trigger. This issue is fixed in versions 3.0.20.0, 3.1.15.0, and 3.2.0.3-beta1. |
| OpenImageIO is a toolset for reading, writing, and manipulating image files of any image file format relevant to VFX / animation. Prior to 3.0.20.0, 3.1.15.0, and 3.2.0.3-beta1, An uncompressed 16-bit iff image with a z-buffer makes iffinput::readimg() allocate a temporary scanline from m_header.rgba_count but copy from it using m_header.pixel_bytes(), whose stride also includes z-buffer bytes. the oversized memcpy reads beyond the temporary heap buffer and copies adjacent memory into the output image, resulting in a crash or disclosure of adjacent heap data. The affected implementation is identified by src/iff.imageio/iffinput.cpp, IffInput::readimg(), m_header.rgba_count, and m_header.pixel_bytes(), which define the relevant source path, functions, state, and trigger. This issue is fixed in versions 3.0.20.0, 3.1.15.0, and 3.2.0.3-beta1. |
| OpenImageIO is a toolset for reading, writing, and manipulating image files of any image file format relevant to VFX / animation. Prior to 3.0.21.0, 3.1.16.0, and 3.2.0.3-beta1, An indexed psd with transparency metadata creates fewer stored channel_buffers than the spec.nchannels value advertised by the rawcolor path. when oiio:rawcolor or psd:rawdata is enabled, psdinput::read_native_scanline() passes spec.nchannels to psdinput::interleave_row(), which indexes beyond channel_buffers, resulting in a heap out-of-bounds read and process crash. The affected implementation is identified by src/psd.imageio/psdinput.cpp, PSDInput::read_native_scanline(), PSDInput::interleave_row(), oiio:RawColor, psd:RawData, channel_buffers, and spec.nchannels, which define the relevant source path, functions, state, and trigger. This issue is fixed in versions 3.0.21.0, 3.1.16.0, and 3.2.0.3-beta1. |
| OpenImageIO is a toolset for reading, writing, and manipulating image files of any image file format relevant to VFX / animation. Prior to 3.0.21.0, 3.1.16.0, and 3.2.0.3-beta1, A valid tiled openexr image whose width is not a multiple of its tile width can trigger an overflow when a caller reads a partial edge-tile rectangle. openexrinput::read_native_tiles() copies each row into the caller buffer using the padded whole-tile scanline_stride rather than user_scanline_bytes for the requested rectangle, resulting in a heap out-of-bounds write and memory corruption. The affected implementation is identified by src/openexr.imageio/exrinput.cpp, OpenEXRInput::read_native_tiles(), partial edge tile, user_scanline_bytes, and scanline_stride, which define the relevant source path, functions, state, and trigger. This issue is fixed in versions 3.0.21.0, 3.1.16.0, and 3.2.0.3-beta1. |
