| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_event: fix potential UAF in SSP passkey handlers
hci_conn lookup and field access must be covered by hdev lock in
hci_user_passkey_notify_evt() and hci_keypress_notify_evt(), otherwise
the connection can be freed concurrently.
Extend the hci_dev_lock critical section to cover all conn usage in both
handlers.
Keep the existing keypress notification behavior unchanged by routing
the early exits through a common unlock path. |
| In the Linux kernel, the following vulnerability has been resolved:
ibmasm: fix heap over-read in ibmasm_send_i2o_message()
The ibmasm_send_i2o_message() function uses get_dot_command_size() to
compute the byte count for memcpy_toio(), but this value is derived from
user-controlled fields in the dot_command_header (command_size: u8,
data_size: u16) and is never validated against the actual allocation size.
A root user can write a small buffer with inflated header fields, causing
memcpy_toio() to read up to ~65 KB past the end of the allocation into
adjacent kernel heap, which is then forwarded to the service processor
over MMIO.
Silently clamping the copy size is not sufficient: if the header fields
claim a larger size than the buffer, the SP receives a dot command whose
own header is inconsistent with the I2O message length, which can cause
the SP to desynchronize. Reject such commands outright by returning
failure.
Validate command_size before calling get_mfa_inbound() to avoid leaking
an I2O message frame: reading INBOUND_QUEUE_PORT dequeues a hardware
frame from the controller's free pool, and returning without a
corresponding set_mfa_inbound() call would permanently exhaust it.
Additionally, clamp command_size to I2O_COMMAND_SIZE before the
memcpy_toio() so the MMIO write stays within the I2O message frame,
consistent with the clamping already performed by outgoing_message_size()
for the header field. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: fix use-after-free in mwifiex_adapter_cleanup()
The mwifiex_adapter_cleanup() function uses timer_delete()
(non-synchronous) for the wakeup_timer before the adapter structure is
freed. This is incorrect because timer_delete() does not wait for any
running timer callback to complete.
If the wakeup_timer callback (wakeup_timer_fn) is executing when
mwifiex_adapter_cleanup() is called, the callback will continue to
access adapter fields (adapter->hw_status, adapter->if_ops.card_reset,
etc.) which may be freed by mwifiex_free_adapter() called later in the
mwifiex_remove_card() path.
Use timer_delete_sync() instead to ensure any running timer callback has
completed before returning. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: atmel-tdes - fix DMA sync direction
Before DMA output is consumed by the CPU, ->dma_addr_out must be synced
with dma_sync_single_for_cpu() instead of dma_sync_single_for_device().
Using the wrong direction can return stale cache data on non-coherent
platforms. |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: fix the out-of-bounds nameoff handling for trailing dirents
Currently we already have boundary-checks for nameoffs, but the trailing
dirents are special since the namelens are calculated with strnlen()
with unchecked nameoffs.
If a crafted EROFS has a trailing dirent with nameoff >= maxsize,
maxsize - nameoff can underflow, causing strnlen() to read past the
directory block.
nameoff0 should also be verified to be a multiple of
`sizeof(struct erofs_dirent)` as well [1].
[1] https://sashiko.dev/#/patchset/20260416063511.3173774-1-hsiangkao%40linux.alibaba.com |
| IBM App Connect Enterprise 13.0.1.0 through 13.0.7.0 stores potentially sensitive information in log files that could be read by a local user. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: acomp - fix wrong pointer stored by acomp_save_req()
acomp_save_req() stores &req->chain in req->base.data. When
acomp_reqchain_done() is invoked on asynchronous completion, it receives
&req->chain as the data argument but casts it directly to struct
acomp_req. Since data points to the chain member, all subsequent field
accesses are at a wrong offset, resulting in memory corruption.
The issue occurs when an asynchronous hardware implementation, such as
the QAT driver, completes a request that uses the DMA virtual address
interface (e.g. acomp_request_set_src_dma()). This combination causes
crypto_acomp_compress() to enter the acomp_do_req_chain() path, which
sets acomp_reqchain_done() as the completion callback via
acomp_save_req().
With KASAN enabled, this manifests as a general protection fault in
acomp_reqchain_done():
general protection fault, probably for non-canonical address 0xe000040000000000
KASAN: probably user-memory-access in range [0x0000400000000000-0x0000400000000007]
RIP: 0010:acomp_reqchain_done+0x15b/0x4e0
Call Trace:
<IRQ>
qat_comp_alg_callback+0x5d/0xa0 [intel_qat]
adf_ring_response_handler+0x376/0x8b0 [intel_qat]
adf_response_handler+0x60/0x170 [intel_qat]
tasklet_action_common+0x223/0x820
handle_softirqs+0x1ab/0x640
</IRQ>
Fix this by storing the request itself in req->base.data instead of
&req->chain, so that acomp_reqchain_done() receives the correct pointer.
Simplify acomp_restore_req() accordingly to access req->chain directly. |
| IBM Web Server Plug-ins for WebSphere Application Server and WebSphere Liberty 8.5, 9.0 IBM WebSphere Application Server and WebSphere Application Server Liberty are vulnerable to remote code execution in the Web Server Plug-ins, through a specially crafted request. |
| Privilege escalation via background service of OpenVPN Connect 3.5.1 through 3.8.1 on macOS allows attackers to execute arbitrary commands with elevated privileges via local IPC channel |
| An insecure password scheme refers to vulnerabilities arising from improper selection of encryption algorithms, inadequate key management, or flawed code implementation, which may lead to data leakage or tampering, such as hard-coded keys or the use of weak encryption algorithms. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: fix resource leaks on device setup failure
Make sure to call controller cleanup() if spi_setup() fails while
registering a device to avoid leaking any resources allocated by
setup(). |
| In the Linux kernel, the following vulnerability has been resolved:
net: bridge: use a stable FDB dst snapshot in RCU readers
Local FDB entries can be rewritten in place by `fdb_delete_local()`, which
updates `f->dst` to another port or to `NULL` while keeping the entry
alive. Several bridge RCU readers inspect `f->dst`, including
`br_fdb_fillbuf()` through the `brforward_read()` sysfs path.
These readers currently load `f->dst` multiple times and can therefore
observe inconsistent values across the check and later dereference.
In `br_fdb_fillbuf()`, this means a concurrent local-FDB update can change
`f->dst` after the NULL check and before the `port_no` dereference,
leading to a NULL-ptr-deref.
Fix this by taking a single `READ_ONCE()` snapshot of `f->dst` in each
affected RCU reader and using that snapshot for the rest of the access
sequence. Also publish the in-place `f->dst` updates in `fdb_delete_local()`
with `WRITE_ONCE()` so the readers and writer use matching access patterns. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon/stat: fix memory leak on damon_start() failure in damon_stat_start()
Destroy the DAMON context and reset the global pointer when damon_start()
fails. Otherwise, the context allocated by damon_stat_build_ctx() is
leaked, and the stale damon_stat_context pointer will be overwritten on
the next enable attempt, making the old allocation permanently
unreachable. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: check for PCI upstream bridge existence
pci_upstream_bridge() returns NULL if the device is on a root bus. If
8821CE is installed in the system with such a PCI topology, the probing
routine will crash. This has probably been unnoticed as 8821CE is mostly
supplied in laptops where there is a PCI-to-PCI bridge located upstream
from the device. However the card might be installed on a system with
different configuration.
Check if the bridge does exist for the specific workaround to be applied.
Found by Linux Verification Center (linuxtesting.org) with Svace static
analysis tool. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ipv6: fix NOREF dst use in seg6 and rpl lwtunnels
seg6_input_core() and rpl_input() call ip6_route_input() which sets a
NOREF dst on the skb, then pass it to dst_cache_set_ip6() invoking
dst_hold() unconditionally.
On PREEMPT_RT, ksoftirqd is preemptible and a higher-priority task can
release the underlying pcpu_rt between the lookup and the caching
through a concurrent FIB lookup on a shared nexthop.
Simplified race sequence:
ksoftirqd/X higher-prio task (same CPU X)
----------- --------------------------------
seg6_input_core(,skb)/rpl_input(skb)
dst_cache_get()
-> miss
ip6_route_input(skb)
-> ip6_pol_route(,skb,flags)
[RT6_LOOKUP_F_DST_NOREF in flags]
-> FIB lookup resolves fib6_nh
[nhid=N route]
-> rt6_make_pcpu_route()
[creates pcpu_rt, refcount=1]
pcpu_rt->sernum = fib6_sernum
[fib6_sernum=W]
-> cmpxchg(fib6_nh.rt6i_pcpu,
NULL, pcpu_rt)
[slot was empty, store succeeds]
-> skb_dst_set_noref(skb, dst)
[dst is pcpu_rt, refcount still 1]
rt_genid_bump_ipv6()
-> bumps fib6_sernum
[fib6_sernum from W to Z]
ip6_route_output()
-> ip6_pol_route()
-> FIB lookup resolves fib6_nh
[nhid=N]
-> rt6_get_pcpu_route()
pcpu_rt->sernum != fib6_sernum
[W <> Z, stale]
-> prev = xchg(rt6i_pcpu, NULL)
-> dst_release(prev)
[prev is pcpu_rt,
refcount 1->0, dead]
dst = skb_dst(skb)
[dst is the dead pcpu_rt]
dst_cache_set_ip6(dst)
-> dst_hold() on dead dst
-> WARN / use-after-free
For the race to occur, ksoftirqd must be preemptible (PREEMPT_RT without
PREEMPT_RT_NEEDS_BH_LOCK) and a concurrent task must be able to release
the pcpu_rt. Shared nexthop objects provide such a path, as two routes
pointing to the same nhid share the same fib6_nh and its rt6i_pcpu
entry.
Fix seg6_input_core() and rpl_input() by calling skb_dst_force() after
ip6_route_input() to force the NOREF dst into a refcounted one before
caching.
The output path is not affected as ip6_route_output() already returns a
refcounted dst. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: reject zero shift in nft_bitwise
Reject zero shift operands for nft_bitwise left and right shift
expressions during initialization.
The carry propagation logic computes the carry from the adjacent 32-bit
word using BITS_PER_TYPE(u32) - shift. A zero shift operand turns this
into a 32-bit shift, which is undefined behaviour.
Reject zero shift operands in the control plane, alongside the existing
check for values greater than or equal to 32, so malformed rules never
reach the packet path. |
| In the Linux kernel, the following vulnerability has been resolved:
can: ucan: fix devres lifetime
USB drivers bind to USB interfaces and any device managed resources
should have their lifetime tied to the interface rather than parent USB
device. This avoids issues like memory leaks when drivers are unbound
without their devices being physically disconnected (e.g. on probe
deferral or configuration changes).
Fix the control message buffer lifetime so that it is released on driver
unbind. |
| IBM WebSphere Application Server - Liberty 22.0.0.11 through 26.0.0.5 IBM WebSphere Application Server Liberty could allow a remote attacker to bypass security under limited conditions by exploiting a specific timing window. |
| Hitachi Vantara Pentaho Data Integration & Analytics versions before 10.2.0.6 and 11.0.0.0, including 9.3.x and 8.3.x, does not apply ACLs on certain API endpoints related to platform mail notfications. |
| Attackers carefully craft malicious scripts, such as JavaScript, and inject them into target systems; when other users access pages containing such malicious content, the scripts are automatically loaded and executed in the victim's browser.Attackers can thereby steal user cookies, hijack session privileges, and tamper with page content.Since the malicious code is stored within the system, the attack scope is broad and the concealment is strong, making it frequently employed for data theft attacks. |
