| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| HCL BigFix Service Management (SM) is affected by an Information Disclosure – Server Banner issue was identified. Exposed server banners may reveal software versions and system details, potentially aiding attackers in targeting known vulnerabilities. |
| HCL BigFix Service Management (SM) application fails to strip EXIF metadata from uploaded images. This could lead to confidentiality and privacy risks if sensitive location information is unintentionally shared. . |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Flush dev-IOTLB only when PCIe device is accessible in scalable mode
Commit 4fc82cd907ac ("iommu/vt-d: Don't issue ATS Invalidation
request when device is disconnected") relies on
pci_dev_is_disconnected() to skip ATS invalidation for
safely-removed devices, but it does not cover link-down caused
by faults, which can still hard-lock the system.
For example, if a VM fails to connect to the PCIe device,
"virsh destroy" is executed to release resources and isolate
the fault, but a hard-lockup occurs while releasing the group fd.
Call Trace:
qi_submit_sync
qi_flush_dev_iotlb
intel_pasid_tear_down_entry
device_block_translation
blocking_domain_attach_dev
__iommu_attach_device
__iommu_device_set_domain
__iommu_group_set_domain_internal
iommu_detach_group
vfio_iommu_type1_detach_group
vfio_group_detach_container
vfio_group_fops_release
__fput
Although pci_device_is_present() is slower than
pci_dev_is_disconnected(), it still takes only ~70 µs on a
ConnectX-5 (8 GT/s, x2) and becomes even faster as PCIe speed
and width increase.
Besides, devtlb_invalidation_with_pasid() is called only in the
paths below, which are far less frequent than memory map/unmap.
1. mm-struct release
2. {attach,release}_dev
3. set/remove PASID
4. dirty-tracking setup
The gain in system stability far outweighs the negligible cost
of using pci_device_is_present() instead of pci_dev_is_disconnected()
to decide when to skip ATS invalidation, especially under GDR
high-load conditions. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Ignore -EBUSY when checking nested events from vcpu_block()
Ignore -EBUSY when checking nested events after exiting a blocking state
while L2 is active, as exiting to userspace will generate a spurious
userspace exit, usually with KVM_EXIT_UNKNOWN, and likely lead to the VM's
demise. Continuing with the wakeup isn't perfect either, as *something*
has gone sideways if a vCPU is awakened in L2 with an injected event (or
worse, a nested run pending), but continuing on gives the VM a decent
chance of surviving without any major side effects.
As explained in the Fixes commits, it _should_ be impossible for a vCPU to
be put into a blocking state with an already-injected event (exception,
IRQ, or NMI). Unfortunately, userspace can stuff MP_STATE and/or injected
events, and thus put the vCPU into what should be an impossible state.
Don't bother trying to preserve the WARN, e.g. with an anti-syzkaller
Kconfig, as WARNs can (hopefully) be added in paths where _KVM_ would be
violating x86 architecture, e.g. by WARNing if KVM attempts to inject an
exception or interrupt while the vCPU isn't running. |
| In the Linux kernel, the following vulnerability has been resolved:
md-cluster: fix NULL pointer dereference in process_metadata_update
The function process_metadata_update() blindly dereferences the 'thread'
pointer (acquired via rcu_dereference_protected) within the wait_event()
macro.
While the code comment states "daemon thread must exist", there is a valid
race condition window during the MD array startup sequence (md_run):
1. bitmap_load() is called, which invokes md_cluster_ops->join().
2. join() starts the "cluster_recv" thread (recv_daemon).
3. At this point, recv_daemon is active and processing messages.
4. However, mddev->thread (the main MD thread) is not initialized until
later in md_run().
If a METADATA_UPDATED message is received from a remote node during this
specific window, process_metadata_update() will be called while
mddev->thread is still NULL, leading to a kernel panic.
To fix this, we must validate the 'thread' pointer. If it is NULL, we
release the held lock (no_new_dev_lockres) and return early, safely
ignoring the update request as the array is not yet fully ready to
process it. |
| In the Linux kernel, the following vulnerability has been resolved:
ring-buffer: Fix possible dereference of uninitialized pointer
There is a pointer head_page in rb_meta_validate_events() which is not
initialized at the beginning of a function. This pointer can be dereferenced
if there is a failure during reader page validation. In this case the control
is passed to "invalid" label where the pointer is dereferenced in a loop.
To fix the issue initialize orig_head and head_page before calling
rb_validate_buffer.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
ceph: supply snapshot context in ceph_zero_partial_object()
The ceph_zero_partial_object function was missing proper snapshot
context for its OSD write operations, which could lead to data
inconsistencies in snapshots.
Reproducer:
../src/vstart.sh --new -x --localhost --bluestore
./bin/ceph auth caps client.fs_a mds 'allow rwps fsname=a' mon 'allow r fsname=a' osd 'allow rw tag cephfs data=a'
mount -t ceph fs_a@.a=/ /mnt/mycephfs/ -o conf=./ceph.conf
dd if=/dev/urandom of=/mnt/mycephfs/foo bs=64K count=1
mkdir /mnt/mycephfs/.snap/snap1
md5sum /mnt/mycephfs/.snap/snap1/foo
fallocate -p -o 0 -l 4096 /mnt/mycephfs/foo
echo 3 > /proc/sys/vm/drop/caches
md5sum /mnt/mycephfs/.snap/snap1/foo # get different md5sum!! |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Add sanity check for OOB writes at silencing
At silencing the playback URB packets in the implicit fb mode before
the actual playback, we blindly assume that the received packets fit
with the buffer size. But when the setup in the capture stream
differs from the playback stream (e.g. due to the USB core limitation
of max packet size), such an inconsistency may lead to OOB writes to
the buffer, resulting in a crash.
For addressing it, add a sanity check of the transfer buffer size at
prepare_silent_urb(), and stop the data copy if the received data
overflows. Also, report back the transfer error properly from there,
too.
Note that this doesn't fix the root cause of the playback error
itself, but this merely covers the kernel Oops. |
| In the Linux kernel, the following vulnerability has been resolved:
mailbox: Prevent out-of-bounds access in fw_mbox_index_xlate()
Although it is guided that `#mbox-cells` must be at least 1, there are
many instances of `#mbox-cells = <0>;` in the device tree. If that is
the case and the corresponding mailbox controller does not provide
`fw_xlate` and of_xlate` function pointers, `fw_mbox_index_xlate()` will
be used by default and out-of-bounds accesses could occur due to lack of
bounds check in that function. |
| CoreDNS is a DNS server that chains plugins. In versions prior to 1.14.3, the DNS-over-QUIC (DoQ) server can be driven into unbounded goroutine and memory growth by a remote client that opens many QUIC streams and sends only 1 byte per stream. When the worker pool is full, CoreDNS still spawns a goroutine per accepted stream to wait for a worker token. Additionally, active workers block indefinitely in io.ReadFull() with no per-stream read deadline, allowing an attacker to pin all workers by sending a single byte so the read blocks waiting for the second byte of the DoQ length prefix. This enables an unauthenticated remote attacker to cause memory exhaustion and OOM-kill. This issue has been fixed in version 1.14.3. No known workarounds exist. |
| A flaw was found in libssh's handling of key exchange (KEX) processes when a client repeatedly sends incorrect KEX guesses. The library fails to free memory during these rekey operations, which can gradually exhaust system memory. This issue can lead to crashes on the client side, particularly when using libgcrypt, which impacts application stability and availability. |
| A vulnerability was found in libssh, where an uninitialized variable exists under certain conditions in the privatekey_from_file() function. This flaw can be triggered if the file specified by the filename doesn't exist and may lead to possible signing failures or heap corruption. |
| Twenty is an open source CRM built with NestJS (Node.js). In versions 1.18.0 and earlier, the SSRF protection in twenty-server's SecureHttpClientService can be bypassed using IPv4-mapped IPv6 addresses in URL IP literals. Node.js's URL parser normalizes IPv4-mapped IPv6 addresses to compressed hex form (e.g., ::ffff:169.254.169.254 becomes ::ffff:a9fe:a9fe), but the isPrivateIp utility only recognizes the dotted-decimal notation. As a result, the hex form passes the SSRF check unchecked. Additionally, the socket lookup validation event does not fire for IP literal addresses, bypassing the second validation layer. An authenticated user can reach any internal IP, including cloud metadata endpoints, to exfiltrate credentials such as IAM keys. |
| Sandboxie-Plus is an open source sandbox-based isolation software for Windows. In versions 1.17.2 and earlier, NamedPipeServer::OpenHandler copies the server field from NAMED_PIPE_OPEN_REQ into a fixed WCHAR pipename[160] stack buffer using wcscat without verifying null termination. The handler only enforces a minimum packet size, and since the service pipe accepts variable-length messages, a sandboxed caller can fill the server[48] field with non-zero data and append additional controlled wide characters after the structure. wcscat then reads past the fixed field and overflows the stack buffer in the SYSTEM service. This message is restricted to sandboxed callers, making it a sandbox escape vector. This can lead to a crash of the SbieSvc service or potential code execution as SYSTEM. This issue has been fixed in version 1.17.3. |
| The WebSocket Application Programming Interface lacks restrictions on the number of authentication requests. This absence of rate limiting may allow an attacker to conduct denial-of-service attacks by suppressing or mis-routing legitimate charger telemetry, or conduct brute-force attacks to gain unauthorized access. |
| Masa CMS is an open source content management system. In versions 7.5.2 and earlier, a SQL injection vulnerability exists in the beanFeed.cfc component within the getQuery function's processing of the sortBy parameter. The application fails to properly sanitize or parameterize this input before incorporating it into dynamic SQL statements. An unauthenticated remote attacker can execute arbitrary SQL commands against the database, potentially gaining access to sensitive data, modifying or deleting records, or escalating privileges to administrative control.
This issue has been fixed in versions 7.2.10, 7.3.15, 7.4.10, and 7.5.3. As a workaround, configure WAF rules to block malicious SQL patterns in the sortBy parameter sent to beanFeed.cfc. |
| A flaw was found in libsoup’s caching mechanism, SoupCache, where the HTTP Vary header is ignored when evaluating cached responses. This header ensures that responses vary appropriately based on request headers such as language or authentication. Without this check, cached content can be incorrectly reused across different requests, potentially exposing sensitive user information. While the issue is unlikely to affect everyday desktop use, it could result in confidentiality breaches in proxy or multi-user environments. |
| Concurrent execution using shared resource with improper synchronization ('race condition') in .NET Framework allows an unauthorized attacker to deny service over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: Fix null pointer dereference issue
If SMU is disabled, during RAS initialization,
there will be null pointer dereference issue here. |
| In the Linux kernel, the following vulnerability has been resolved:
dm-verity: correctly handle dm_bufio_client_create() failure
If either of the calls to dm_bufio_client_create() in verity_fec_ctr()
fails, then dm_bufio_client_destroy() is later called with an ERR_PTR()
argument. That causes a crash. Fix this. |
