| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| go-git is an extensible git implementation library written in pure Go. Prior to versions 5.18.0 and 6.0.0-alpha.2, go-git may leak HTTP authentication credentials when following redirects during smart-HTTP clone and fetch operations. This issue has been patched in versions 5.18.0 and 6.0.0-alpha.2. |
| In the Linux kernel, the following vulnerability has been resolved:
arm64: dts: qcom: monaco: Reserve full Gunyah metadata region
We observe spurious "Synchronous External Abort" exceptions
(ESR=0x96000010) and kernel crashes on Monaco-based platforms.
These faults are caused by the kernel inadvertently accessing
hypervisor-owned memory that is not properly marked as reserved.
>From boot log, The Qualcomm hypervisor reports the memory range
at 0x91a80000 of size 0x80000 (512 KiB) as hypervisor-owned:
qhee_hyp_assign_remove_memory: 0x91a80000/0x80000 -> ret 0
However, the EFI memory map provided by firmware only reserves the
subrange 0x91a40000–0x91a87fff (288 KiB). The remaining portion
(0x91a88000–0x91afffff) is incorrectly reported as conventional
memory (from efi debug):
efi: 0x000091a40000-0x000091a87fff [Reserved...]
efi: 0x000091a88000-0x0000938fffff [Conventional...]
As a result, the allocator may hand out PFNs inside the hypervisor
owned region, causing fatal aborts when the kernel accesses those
addresses.
Add a reserved-memory carveout for the Gunyah hypervisor metadata
at 0x91a80000 (512 KiB) and mark it as no-map so Linux does not
map or allocate from this area.
For the record:
Hyp version: gunyah-e78adb36e debug (2025-11-17 05:38:05 UTC)
UEFI Ver: 6.0.260122.BOOT.MXF.1.0.c1-00449-KODIAKLA-1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: ipa: fix event ring index not programmed for IPA v5.0+
For IPA v5.0+, the event ring index field moved from CH_C_CNTXT_0 to
CH_C_CNTXT_1. The v5.0 register definition intended to define this
field in the CH_C_CNTXT_1 fmask array but used the old identifier of
ERINDEX instead of CH_ERINDEX.
Without a valid event ring, GSI channels could never signal transfer
completions. This caused gsi_channel_trans_quiesce() to block
forever in wait_for_completion().
At least for IPA v5.2 this resolves an issue seen where runtime
suspend, system suspend, and remoteproc stop all hanged forever. It
also meant the IPA data path was completely non functional. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: prevent possible UaF in addrconf_permanent_addr()
The mentioned helper try to warn the user about an exceptional
condition, but the message is delivered too late, accessing the ipv6
after its possible deletion.
Reorder the statement to avoid the possible UaF; while at it, place the
warning outside the idev->lock as it needs no protection. |
| In the Linux kernel, the following vulnerability has been resolved:
thermal: core: Fix thermal zone device registration error path
If thermal_zone_device_register_with_trips() fails after registering
a thermal zone device, it needs to wait for the tz->removal completion
like thermal_zone_device_unregister(), in case user space has managed
to take a reference to the thermal zone device's kobject, in which case
thermal_release() may not be called by the error path itself and tz may
be freed prematurely.
Add the missing wait_for_completion() call to the thermal zone device
registration error path. |
| In the Linux kernel, the following vulnerability has been resolved:
cpufreq: governor: fix double free in cpufreq_dbs_governor_init() error path
When kobject_init_and_add() fails, cpufreq_dbs_governor_init() calls
kobject_put(&dbs_data->attr_set.kobj).
The kobject release callback cpufreq_dbs_data_release() calls
gov->exit(dbs_data) and kfree(dbs_data), but the current error path
then calls gov->exit(dbs_data) and kfree(dbs_data) again, causing a
double free.
Keep the direct kfree(dbs_data) for the gov->init() failure path, but
after kobject_init_and_add() has been called, let kobject_put() handle
the cleanup through cpufreq_dbs_data_release(). |
| In the Linux kernel, the following vulnerability has been resolved:
sched_ext: Fix SCX_KICK_WAIT deadlock by deferring wait to balance callback
SCX_KICK_WAIT busy-waits in kick_cpus_irq_workfn() using
smp_cond_load_acquire() until the target CPU's kick_sync advances. Because
the irq_work runs in hardirq context, the waiting CPU cannot reschedule and
its own kick_sync never advances. If multiple CPUs form a wait cycle, all
CPUs deadlock.
Replace the busy-wait in kick_cpus_irq_workfn() with resched_curr() to
force the CPU through do_pick_task_scx(), which queues a balance callback
to perform the wait. The balance callback drops the rq lock and enables
IRQs following the sched_core_balance() pattern, so the CPU can process
IPIs while waiting. The local CPU's kick_sync is advanced on entry to
do_pick_task_scx() and continuously during the wait, ensuring any CPU that
starts waiting for us sees the advancement and cannot form cyclic
dependencies. |
| In the Linux kernel, the following vulnerability has been resolved:
USB: dummy-hcd: Fix interrupt synchronization error
This fixes an error in synchronization in the dummy-hcd driver. The
error has a somewhat involved history. The synchronization mechanism
was introduced by commit 7dbd8f4cabd9 ("USB: dummy-hcd: Fix erroneous
synchronization change"), which added an emulated "interrupts enabled"
flag together with code emulating synchronize_irq() (it waits until
all current handler callbacks have returned).
But the emulated interrupt-disable occurred too late, after the driver
containing the handler callback routines had been told that it was
unbound and no more callbacks would occur. Commit 4a5d797a9f9c ("usb:
gadget: dummy_hcd: fix gpf in gadget_setup") tried to fix this by
moving the synchronize_irq() emulation code from dummy_stop() to
dummy_pullup(), which runs before the unbind callback.
There still were races, though, because the emulated interrupt-disable
still occurred too late. It couldn't be moved to dummy_pullup(),
because that routine can be called for reasons other than an impending
unbind. Therefore commits 7dc0c55e9f30 ("USB: UDC core: Add
udc_async_callbacks gadget op") and 04145a03db9d ("USB: UDC: Implement
udc_async_callbacks in dummy-hcd") added an API allowing the UDC core
to tell dummy-hcd exactly when emulated interrupts and their callbacks
should be disabled.
That brings us to the current state of things, which is still wrong
because the emulated synchronize_irq() occurs before the emulated
interrupt-disable! That's no good, beause it means that more emulated
interrupts can occur after the synchronize_irq() emulation has run,
leading to the possibility that a callback handler may be running when
the gadget driver is unbound.
To fix this, we have to move the synchronize_irq() emulation code yet
again, to the dummy_udc_async_callbacks() routine, which takes care of
enabling and disabling emulated interrupt requests. The
synchronization will now run immediately after emulated interrupts are
disabled, which is where it belongs. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: spidev: fix lock inversion between spi_lock and buf_lock
The spidev driver previously used two mutexes, spi_lock and buf_lock,
but acquired them in different orders depending on the code path:
write()/read(): buf_lock -> spi_lock
ioctl(): spi_lock -> buf_lock
This AB-BA locking pattern triggers lockdep warnings and can
cause real deadlocks:
WARNING: possible circular locking dependency detected
spidev_ioctl() -> mutex_lock(&spidev->buf_lock)
spidev_sync_write() -> mutex_lock(&spidev->spi_lock)
*** DEADLOCK ***
The issue is reproducible with a simple userspace program that
performs write() and SPI_IOC_WR_MAX_SPEED_HZ ioctl() calls from
separate threads on the same spidev file descriptor.
Fix this by simplifying the locking model and removing the lock
inversion entirely. spidev_sync() no longer performs any locking,
and all callers serialize access using spi_lock.
buf_lock is removed since its functionality is fully covered by
spi_lock, eliminating the possibility of lock ordering issues.
This removes the lock inversion and prevents deadlocks without
changing userspace ABI or behaviour. |
| In the Linux kernel, the following vulnerability has been resolved:
most: core: fix leak on early registration failure
A recent commit fixed a resource leak on early registration failures but
for some reason left out the first error path which still leaks the
resources associated with the interface.
Fix up also the first error path so that the interface is always
released on errors. |
| In the Linux kernel, the following vulnerability has been resolved:
media: solo6x10: Check for out of bounds chip_id
Clang with CONFIG_UBSAN_SHIFT=y noticed a condition where a signed type
(literal "1" is an "int") could end up being shifted beyond 32 bits,
so instrumentation was added (and due to the double is_tw286x() call
seen via inlining), Clang decides the second one must now be undefined
behavior and elides the rest of the function[1]. This is a known problem
with Clang (that is still being worked on), but we can avoid the entire
problem by actually checking the existing max chip ID, and now there is
no runtime instrumentation added at all since everything is known to be
within bounds.
Additionally use an unsigned value for the shift to remove the
instrumentation even without the explicit bounds checking.
[hverkuil: fix checkpatch warning for is_tw286x] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/panthor: fix for dma-fence safe access rules
Commit 506aa8b02a8d6 ("dma-fence: Add safe access helpers and document
the rules") details the dma-fence safe access rules. The most common
culprit is that drm_sched_fence_get_timeline_name may race with
group_free_queue. |
| Memory safety bugs present in Thunderbird 150.0.1. Some of these bugs showed evidence of memory corruption and we presume that with enough effort some of these could have been exploited to run arbitrary code. This vulnerability was fixed in Firefox 150.0.2 and Thunderbird 150.0.2. |
| ** REJECT ** DO NOT USE THIS CANDIDATE NUMBER. Reason: This candidate was issued in error. Notes: All references and descriptions in this candidate have been removed to prevent accidental usage. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in Kriesi Enfold allows DOM-Based XSS.
This issue affects Enfold: from n/a through 7.1.3. |
| SEPPmail Secure Email Gateway before version 15.0.4 fails to enforce authorization checks for multiple endpoints in the new GINA UI, allowing unauthenticated remote attackers to access functionality that should require a valid session. |
| SEPPmail Secure Email Gateway before version 15.0.4 contains a server-side template injection vulnerability in the new GINA UI because an endpoint accepts attacker-controlled template, allowing remote attackers to execute arbitrary template expressions and potentially achieve remote code execution depending on the enabled template plugins. |
| YARD is a Ruby Documentation tool. Prior to version 0.9.42, a path traversal vulnerability was discovered in YARD when using yard server to serve documentation. This bug would allow unsanitized HTTP requests to access arbitrary files on the machine of a yard server host under certain conditions. This issue has been patched in version 0.9.42. |
| SEPPmail Secure Email Gateway before version 15.0.2.1 allows unauthenticated remote code execution in the new GINA UI because an endpoint passes attacker-controlled input from a parameter to Perl's eval. |
| SEPPmail Secure Email Gateway before version 15.0.4 contains an unauthenticated path traversal vulnerability in the identifier parameter of /api.app/attachment/preview that allows remote attackers to read arbitrary local files and trigger deletion of files in the targeted directory with the privileges of the api.app process. |
