| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
netfs: Fix NULL pointer dereference in netfs_unbuffered_write() on retry
When a write subrequest is marked NETFS_SREQ_NEED_RETRY, the retry path
in netfs_unbuffered_write() unconditionally calls stream->prepare_write()
without checking if it is NULL.
Filesystems such as 9P do not set the prepare_write operation, so
stream->prepare_write remains NULL. When get_user_pages() fails with
-EFAULT and the subrequest is flagged for retry, this results in a NULL
pointer dereference at fs/netfs/direct_write.c:189.
Fix this by mirroring the pattern already used in write_retry.c: if
stream->prepare_write is NULL, skip renegotiation and directly reissue
the subrequest via netfs_reissue_write(), which handles iterator reset,
IN_PROGRESS flag, stats update and reissue internally. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: xilinx: xdma: Fix regmap init error handling
devm_regmap_init_mmio returns an ERR_PTR() upon error, not NULL.
Fix the error check and also fix the error message. Use the error code
from ERR_PTR() instead of the wrong value in ret. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: Fix leaking event log memory
During the device remove process, the device is reset, causing the
configuration registers to go back to their default state, which is
zero. As the driver is checking if the event log support was enabled
before deallocating, it will fail if a reset happened before.
Do not check if the support was enabled, the check for 'idxd->evl'
being valid (only allocated if the HW capability is available) is
enough. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: stop reclaim before pushing AIL during unmount
The unmount sequence in xfs_unmount_flush_inodes() pushed the AIL while
background reclaim and inodegc are still running. This is broken
independently of any use-after-free issues - background reclaim and
inodegc should not be running while the AIL is being pushed during
unmount, as inodegc can dirty and insert inodes into the AIL during the
flush, and background reclaim can race to abort and free dirty inodes.
Reorder xfs_unmount_flush_inodes() to stop inodegc and cancel background
reclaim before pushing the AIL. Stop inodegc before cancelling
m_reclaim_work because the inodegc worker can re-queue m_reclaim_work
via xfs_inodegc_set_reclaimable. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon/sysfs: fix param_ctx leak on damon_sysfs_new_test_ctx() failure
Patch series "mm/damon/sysfs: fix memory leak and NULL dereference
issues", v4.
DAMON_SYSFS can leak memory under allocation failure, and do NULL pointer
dereference when a privileged user make wrong sequences of control. Fix
those.
This patch (of 3):
When damon_sysfs_new_test_ctx() fails in damon_sysfs_commit_input(),
param_ctx is leaked because the early return skips the cleanup at the out
label. Destroy param_ctx before returning. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: check if ext_caps is valid in BL setup
LVDS connectors don't have extended backlight caps so check
if the pointer is valid before accessing it.
(cherry picked from commit 3f797396d7f4eb9bb6eded184bbc6f033628a6f6) |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Drain deferred trigger frees if kthread creation fails
Boot-time trigger registration can fail before the trigger-data cleanup
kthread exists. Deferring those frees until late init is fine, but the
post-boot fallback must still drain the deferred list if kthread
creation never succeeds.
Otherwise, boot-deferred nodes can accumulate on
trigger_data_free_list, later frees fall back to synchronously freeing
only the current object, and the older queued entries are leaked
forever.
To trigger this, add the following to the kernel command line:
trace_event=sched_switch trace_trigger=sched_switch.traceon,sched_switch.traceon
The second traceon trigger will fail and be freed. This triggers a NULL
pointer dereference and crashes the kernel.
Keep the deferred boot-time behavior, but when kthread creation fails,
drain the whole queued list synchronously. Do the same in the late-init
drain path so queued entries are not stranded there either. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/entry: Scrub r12 register on kernel entry
Before commit f33f2d4c7c80 ("s390/bp: remove TIF_ISOLATE_BP"),
all entry handlers loaded r12 with the current task pointer
(lg %r12,__LC_CURRENT) for use by the BPENTER/BPEXIT macros. That
commit removed TIF_ISOLATE_BP, dropping both the branch prediction
macros and the r12 load, but did not add r12 to the register clearing
sequence.
Add the missing xgr %r12,%r12 to make the register scrub consistent
across all entry points. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/syscalls: Add spectre boundary for syscall dispatch table
The s390 syscall number is directly controlled by userspace, but does
not have an array_index_nospec() boundary to prevent access past the
syscall function pointer tables. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: spi-fsl-lpspi: fix teardown order issue (UAF)
There is a teardown order issue in the driver. The SPI controller is
registered using devm_spi_register_controller(), which delays
unregistration of the SPI controller until after the fsl_lpspi_remove()
function returns.
As the fsl_lpspi_remove() function synchronously tears down the DMA
channels, a running SPI transfer triggers the following NULL pointer
dereference due to use after free:
| fsl_lpspi 42550000.spi: I/O Error in DMA RX
| Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
[...]
| Call trace:
| fsl_lpspi_dma_transfer+0x260/0x340 [spi_fsl_lpspi]
| fsl_lpspi_transfer_one+0x198/0x448 [spi_fsl_lpspi]
| spi_transfer_one_message+0x49c/0x7c8
| __spi_pump_transfer_message+0x120/0x420
| __spi_sync+0x2c4/0x520
| spi_sync+0x34/0x60
| spidev_message+0x20c/0x378 [spidev]
| spidev_ioctl+0x398/0x750 [spidev]
[...]
Switch from devm_spi_register_controller() to spi_register_controller() in
fsl_lpspi_probe() and add the corresponding spi_unregister_controller() in
fsl_lpspi_remove(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btusb: clamp SCO altsetting table indices
btusb_work() maps the number of active SCO links to USB alternate
settings through a three-entry lookup table when CVSD traffic uses
transparent voice settings. The lookup currently indexes alts[] with
data->sco_num - 1 without first constraining sco_num to the number of
available table entries.
While the table only defines alternate settings for up to three SCO
links, data->sco_num comes from hci_conn_num() and is used directly.
Cap the lookup to the last table entry before indexing it so the
driver keeps selecting the highest supported alternate setting without
reading past alts[]. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Fix ERTM re-init and zero pdu_len infinite loop
l2cap_config_req() processes CONFIG_REQ for channels in BT_CONNECTED
state to support L2CAP reconfiguration (e.g. MTU changes). However,
since both CONF_INPUT_DONE and CONF_OUTPUT_DONE are already set from
the initial configuration, the reconfiguration path falls through to
l2cap_ertm_init(), which re-initializes tx_q, srej_q, srej_list, and
retrans_list without freeing the previous allocations and sets
chan->sdu to NULL without freeing the existing skb. This leaks all
previously allocated ERTM resources.
Additionally, l2cap_parse_conf_req() does not validate the minimum
value of remote_mps derived from the RFC max_pdu_size option. A zero
value propagates to l2cap_segment_sdu() where pdu_len becomes zero,
causing the while loop to never terminate since len is never
decremented, exhausting all available memory.
Fix the double-init by skipping l2cap_ertm_init() and
l2cap_chan_ready() when the channel is already in BT_CONNECTED state,
while still allowing the reconfiguration parameters to be updated
through l2cap_parse_conf_req(). Also add a pdu_len zero check in
l2cap_segment_sdu() as a safeguard. |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: nci: fix circular locking dependency in nci_close_device
nci_close_device() flushes rx_wq and tx_wq while holding req_lock.
This causes a circular locking dependency because nci_rx_work()
running on rx_wq can end up taking req_lock too:
nci_rx_work -> nci_rx_data_packet -> nci_data_exchange_complete
-> __sk_destruct -> rawsock_destruct -> nfc_deactivate_target
-> nci_deactivate_target -> nci_request -> mutex_lock(&ndev->req_lock)
Move the flush of rx_wq after req_lock has been released.
This should safe (I think) because NCI_UP has already been cleared
and the transport is closed, so the work will see it and return
-ENETDOWN.
NIPA has been hitting this running the nci selftest with a debug
kernel on roughly 4% of the runs. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Validate PDU length before reading SDU length in l2cap_ecred_data_rcv()
l2cap_ecred_data_rcv() reads the SDU length field from skb->data using
get_unaligned_le16() without first verifying that skb contains at least
L2CAP_SDULEN_SIZE (2) bytes. When skb->len is less than 2, this reads
past the valid data in the skb.
The ERTM reassembly path correctly calls pskb_may_pull() before reading
the SDU length (l2cap_reassemble_sdu, L2CAP_SAR_START case). Apply the
same validation to the Enhanced Credit Based Flow Control data path. |
| In the Linux kernel, the following vulnerability has been resolved:
driver core: platform: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1] |
| In the Linux kernel, the following vulnerability has been resolved:
nvme-pci: ensure we're polling a polled queue
A user can change the polled queue count at run time. There's a brief
window during a reset where a hipri task may try to poll that queue
before the block layer has updated the queue maps, which would race with
the now interrupt driven queue and may cause double completions. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: asus: avoid memory leak in asus_report_fixup()
The asus_report_fixup() function was returning a newly allocated
kmemdup()-allocated buffer, but never freeing it. Switch to
devm_kzalloc() to ensure the memory is managed and freed automatically
when the device is removed.
The caller of report_fixup() does not take ownership of the returned
pointer, but it is permitted to return a pointer whose lifetime is at
least that of the input buffer.
Also fix a harmless out-of-bounds read by copying only the original
descriptor size. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: replace BUG_ON with proper error handling in ext4_read_inline_folio
Replace BUG_ON() with proper error handling when inline data size
exceeds PAGE_SIZE. This prevents kernel panic and allows the system to
continue running while properly reporting the filesystem corruption.
The error is logged via ext4_error_inode(), the buffer head is released
to prevent memory leak, and -EFSCORRUPTED is returned to indicate
filesystem corruption. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: apple: avoid memory leak in apple_report_fixup()
The apple_report_fixup() function was returning a
newly kmemdup()-allocated buffer, but never freeing it.
The caller of report_fixup() does not take ownership of the returned
pointer, but it *is* permitted to return a sub-portion of the input
rdesc, whose lifetime is managed by the caller. |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: set fileio bio failed in short read case
For file-backed mount, IO requests are handled by vfs_iocb_iter_read().
However, it can be interrupted by SIGKILL, returning the number of
bytes actually copied. Unused folios in bio are unexpectedly marked
as uptodate.
vfs_read
filemap_read
filemap_get_pages
filemap_readahead
erofs_fileio_readahead
erofs_fileio_rq_submit
vfs_iocb_iter_read
filemap_read
filemap_get_pages <= detect signal
erofs_fileio_ki_complete <= set all folios uptodate
This patch addresses this by setting short read bio with an error
directly. |
