| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: ad_sigma_delta: fix clear_pending_event for registerless devices
ad_sigma_delta_clear_pending_event() falls through to the status register
read path for devices with has_registers = false and no rdy_gpiod. For
such devices, ad_sd_read_reg() skips the address byte entirely and clocks
raw MISO bytes with no address phase — making it byte-for-byte identical
to reading conversion data. If a pending conversion result is present,
this partially consumes it and corrupts the data stream for the subsequent
ad_sd_read_reg() call in ad_sigma_delta_single_conversion().
Furthermore, with num_resetclks = 0 on these devices, data_read_len
evaluates to 0. If the clocked byte has bit 7 clear, pending_event is set
and the code attempts memset(data + 2, 0xff, 0 - 1), overflowing to
SIZE_MAX and corrupting the heap.
Fix by returning 0 immediately when neither rdy_gpiod nor has_registers
is set. This is safe for all current registerless devices: ad7191 and
ad7780 (with powerdown GPIO) are reset between conversions by CS
deassertion, so there is no stale result to drain; ad7780 (without
powerdown GPIO) and max11205 are continuously-converting and cycle ~DRDY
at the output data rate regardless of whether the previous result was
read, so the next falling edge fires naturally.
A future registerless device that holds ~DRDY asserted until data is read
would be broken by this early return and would require either
num_resetclks set or a rdy-gpio.
The same heap corruption is reachable on any device with rdy_gpiod set
but num_resetclks = 0: if the GPIO indicates a pending event, the drain
path executes memset(data + 2, 0xff, 0 - 1) regardless of has_registers.
Add an explicit data_read_len == 0 guard after the pending event check;
the stale result is then consumed by the first ad_sd_read_reg() call in
ad_sigma_delta_single_conversion(). |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Bound PARTITION_INFO_GET_REGS copies
The register-based PARTITION_INFO_GET path trusted the firmware-provided
indices when copying partition descriptors into the caller buffer.
Reject inconsistent counts or index progressions so the copy loop cannot
write past the allocated array.
(fixed cur_idx when exactly one descriptor in the first fragment) |
| Out of bounds write in ANGLE in Google Chrome prior to 151.0.7922.72 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Heap buffer overflow in Color in Google Chrome on ChromeOS prior to 151.0.7922.72 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds write in WebGL in Google Chrome on Android prior to 151.0.7922.72 allowed a remote attacker to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds read and write in Tint in Google Chrome prior to 150.0.7871.46 allowed a remote attacker to potentially perform out of bounds memory access via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds write in ANGLE in Google Chrome on Mac prior to 150.0.7871.46 allowed a remote attacker to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: Medium) |
| Insufficient validation of untrusted input in Variations in Google Chrome prior to 151.0.7922.72 allowed an attacker in a privileged network position to potentially exploit heap corruption via malicious network traffic. (Chromium security severity: Medium) |
| A potential out of bounds write vulnerability could allow a local privileged attacker to execute code in System Management Mode. |
| CVE-2026-40953 is a heap overflow in the
certificate parsing function of Secure Access clients prior to 14.55. Attackers
with local access and administrator permissions can create a denial of service
attack against the client over which they have control. |
| ncnn is a high-performance neural network inference framework optimized for the mobile platform. In commit e54f7b1f88434e1d844ea0551b880a1cfb079ce1 and earlier, ncnn allows an out-of-bounds heap write in ncnn::ParamDict::load_param() when Net::load_param() loads a malicious .param model file because the parsed parameter id is checked only against id >= NCNN_MAX_PARAM_COUNT, allowing a negative id to index before the params[NCNN_MAX_PARAM_COUNT] array. This vulnerability is fixed by commit 5a0288f255daa6c3294f77109f67718e434ec020. |
| The illumos SCTP inbound path performs association lookup for INIT ACK chunks without adequately validating the address parameters carried in the chunk. Since this lookup runs during packet classification (i.e. before SCTP integrity checks or IPsec policy are applied) a remote, unauthenticated attacker can send a crafted SCTP INIT ACK packet with malformed address parameters to cause an out-of-bounds access and kernel heap corruption, which may lead to remote code execution. The flaw has existed since 2010 (illumos-gate commit a5407c02), and affects any illumos distribution prior to illumos-gate commit 53a3efde. |
| Out of bounds write in ANGLE in Google Chrome prior to 151.0.7922.72 allowed a remote attacker to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| OpenVPN version 2.1.0 through 2.6.20 and 2.7_alpha1 through 2.7.4 allows attackers via an off-by-one buffer write in the NTLM proxy authentication to potentially cause a crash via a crafted NTLM response from a malicious proxy server |
| Heap buffer overflow in Dawn in Google Chrome prior to 151.0.7922.72 allowed a remote attacker to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: Medium) |
| Use after free in Views in Google Chrome on Mac prior to 151.0.7922.72 allowed a remote attacker to potentially exploit heap corruption via a crafted HTML page. (Chromium security severity: Medium) |
| Heap buffer overflow in Codecs in Google Chrome prior to 151.0.7922.72 allowed a remote attacker to execute arbitrary code inside a sandbox via a crafted HTML page. (Chromium security severity: Low) |
| Out of bounds write in ANGLE in Google Chrome on Windows prior to 151.0.7922.72 allowed a remote attacker to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Bridge is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| An out-of-bounds write vulnerability was found in the BFD library's DLX ELF backend (bfd/elf32-dlx.c) in GNU binutils. The dlx_rtype_to_howto() function maps ELF relocation types to internal howto structures but fails to perform adequate bounds checking on attacker-controlled relocation type values (via ELF32_R_TYPE(r_info)) before indexing into the dlx_elf_howto_table[] array. The DLX relocation type number space is non-contiguous (basic types 0-6, extended types at 0x10000+), but the default case in the switch statement allows arbitrary index values to reach the array access.
A specially crafted ELF/DLX object file can trigger this out-of-bounds write when processed by any BFD-consuming tool (objdump, readelf, strip, ld, nm, objcopy). The vulnerability has been demonstrated to achieve arbitrary code execution via a File Stream Oriented Programming (FSOP) attack against glibc FILE structures (stderr), redirecting control flow to system().
Attack scenarios include CI/CD pipelines performing automated binary analysis, developer workstations running objdump/readelf on untrusted binaries, automated security scanning or malware analysis tools invoking binutils, and package build systems processing third-party code.
Note: This vulnerability is only exploitable when binutils is built with the DLX backend enabled (typically via --enable-targets=all). |
