| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: carl9170: fix OOB read from off-by-two in TX status handler
The bounds check in carl9170_tx_process_status() uses
`i > ((cmd->hdr.len / 2) + 1)` which is off by two, allowing
2 extra iterations past valid _tx_status entries when the firmware-
controlled hdr.ext exceeds hdr.len/2. Fix by using the correct
comparison `i >= (cmd->hdr.len / 2)`. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath6kl: fix OOB read from firmware IE lengths in connect event
The firmware-controlled beacon_ie_len, assoc_req_len, and assoc_resp_len
fields in ath6kl_wmi_connect_event_rx() are not validated against the
buffer length. Their sum (up to 765) can exceed the actual WMI event
data, causing out-of-bounds reads during IE parsing and state corruption
of wmi->is_wmm_enabled.
Add a check that the total IE length fits within the buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
firewire: net: Fix fragmented datagram reassembly
fwnet_frag_new() keeps a sorted list of received fragments for a partial
datagram. When a new fragment is adjacent to an existing fragment, the
code checks whether the new fragment also closes the gap to the next or
previous list entry.
Those neighbor lookups currently assume that the current fragment always
has a real next or previous fragment. At a list edge, the next or
previous entry is the list head, not a struct fwnet_fragment_info.
The gap checks also compare against the old edge of the current fragment
instead of the edge after adding the new fragment. As a result, a
fragment that bridges two existing ranges may leave two adjacent ranges
unmerged, so fwnet_pd_is_complete() can miss a complete datagram.
Check for the list head before looking up the neighboring fragment, and
compare the neighbor against the new fragment's far edge when deciding
whether to merge all three ranges.
This issue was found by a static analysis checker and confirmed by
manual source review. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix potential buffer underflow in ath11k_hal_rx_msdu_list_get()
When the first entry in msdu_details has a zero buffer address,
the code accesses msdu_details[i - 1] with i == 0, causing a
buffer underflow.
Fix similarly to ath12k_wifi7_hal_rx_msdu_list_get() by adding
a separate check for i == 0 before the main condition to prevent
the out-of-bounds access.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
watchdog: pretimeout: Fix UAF in watchdog_unregister_governor()
When a watchdog governor is unregistered, it updates existing watchdog
devices that were using this governor by falling back to `default_gov`.
If the governor being unregistered is currently set as `default_gov`,
the `default_gov` is never cleared. This leads to 2 use-after-free
issues:
1. New watchdog devices registered after this point will inherit the
dangling `default_gov`.
2. Existing watchdog devices using the unregistered governor will have
their `wdd->gov` reassigned to the dangling `default_gov`.
Fix the UAF by clearing `default_gov` if it matches the governor being
unregistered. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (nzxt-kraken3) Stop device IO before calling hid_hw_stop
Calling hid_hw_stop() does not stop the device IO.
This results in a race condition between hid_input_report() and the point
immediately following the execution of hid_device_io_start() within
the driver probe function. If the probe operation fails after "io start"
has been initiated, this race condition will result in a UAF vulnerability.
Fix the problem by calling hid_device_io_stop() before calling
hid_hw_stop(). |
| In the Linux kernel, the following vulnerability has been resolved:
USB: serial: io_edgeport: cap received transmit credits
The interrupt-status packet reports transmit credits returned by the
device. edge_interrupt_callback() adds the 16-bit value to txCredits
without checking maxTxCredits.
edge_write() uses txCredits minus the software FIFO count as the amount
of data that fits. Since the FIFO is allocated with maxTxCredits bytes,
txCredits exceeding maxTxCredits can cause OOB write in ring buffer.
Cap accumulated credits at maxTxCredits. Conforming devices should never
hit the cap. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_ncm: validate datagram bounds in ncm_unwrap_ntb()
When unpacking host-supplied NTBs, ncm_unwrap_ntb() checks datagram length
against frame_max but does not verify that the datagram fits within the
declared block length. Additionally, when decoding multiple NTBs from a
single socket buffer, subsequent block lengths are not checked against the
actual remaining buffer data.
With these checks missing, a malicious USB host can specify datagram
offsets and lengths that point beyond the block, or supply secondary NTB
headers declaring lengths larger than the buffer. skb_put_data() then
copies adjacent kernel memory from skb_shared_info into the network skb.
Fix this by verifying that sufficient buffer space remains for the NTB
header before parsing, handling zero-length block declarations, ensuring
that block lengths never exceed the remaining buffer space, and verifying
that each datagram payload stays strictly within the block boundary. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: core: port: Deattach Type-C connector on component unbind
connector_unbind() is the mirror of connector_bind(), but it is missing
the symmetric call to typec_deattach() that connector_bind() makes via:
if (port_dev->child)
typec_attach(port_dev->connector, &port_dev->child->dev);
When a Thunderbolt dock is unplugged, two teardown paths race:
1. The component framework calls connector_unbind() first, which sets
port_dev->connector = NULL without calling typec_deattach(). This
leaves port->usb2_dev/port->usb3_dev in struct typec_port pointing at
the USB device that is about to be freed.
2. usb_disconnect() then calls typec_deattach(port_dev->connector, ...),
but port_dev->connector is already NULL, so the call is a no-op and
port->usb2_dev is never cleared.
3. Concurrently, UCSI detects a PD partner-disconnect event and calls
typec_unregister_partner(), which reads port->usb2_dev (now a dangling
pointer to freed memory) and passes it to typec_partner_unlink_device()
-> sysfs_remove_link() -> dev_name() on the freed device, corrupting
the typec/UCSI partner state.
This corruption leaves the Thunderbolt tunnel in an inconsistent state on
the next dock hot-plug. On affected hardware the dock's I225/igc NIC fails
to enumerate: AER fires a slot reset while the igc driver is still
initialising ("PCIe link lost"), and the subsequent igc_reset attempt hits
igc_rd32 on an already-detached device:
igc 0000:2e:00.0 eth0: PCIe link lost, device now detached
igc: Failed to read reg 0x0!
WARNING: CPU: 9 PID: 129 at drivers/net/ethernet/intel/igc/igc_main.c:7005
igc_rd32+0xa4/0xc0 [igc]
Call Trace:
igc_disable_pcie_master+0x16/0xa0 [igc]
igc_reset_hw_base+0x14/0x170 [igc]
igc_reset+0x63/0x110 [igc]
igc_io_slot_reset+0x9e/0xd0 [igc]
report_slot_reset+0x5d/0xc0
pcie_do_recovery+0x209/0x400
aer_isr_one_error_type+0x235/0x430
aer_isr+0x4e/0x80
irq_thread+0xf4/0x1f0
4. UCSI later handles the PD partner-disconnect and calls
typec_unregister_partner(), which still sees the stale port->usb2_dev
and tries to remove its sysfs link a second time:
kernfs: can not remove 'typec', no directory
WARNING: CPU: 6 PID: 55 at fs/kernfs/dir.c:1706 kernfs_remove_by_name_ns+0xe9/0xf0
Workqueue: events ucsi_handle_connector_change [typec_ucsi]
Call Trace:
sysfs_remove_link+0x19/0x50
typec_unregister_partner+0x6e/0x120 [typec]
ucsi_unregister_partner+0x107/0x150 [typec_ucsi]
ucsi_handle_connector_change+0x3ec/0x490 [typec_ucsi]
process_one_work+0x18e/0x3e0
worker_thread+0x2e3/0x420
kthread+0x10a/0x230
ret_from_fork+0x121/0x140
ret_from_fork_asm+0x1a/0x30
With worse timing the same stale pointer is dereferenced after the
backing memory is freed, turning the warning into a use-after-free.
Fix the asymmetry: call typec_deattach() before clearing
port_dev->connector, matching what connector_bind() does on the bind side.
typec_partner_deattach() is already protected by port->partner_link_lock,
so it serialises safely with the concurrent typec_unregister_partner() path. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Fix Endpoint Memory Access Descriptor offset calculation
Use the descriptor's `ep_mem_offset` to calculate the start of the endpoint
memory access array and to comply with the FF-A spec instead of defaulting
to `sizeof(struct ffa_mem_region)`.
This requires moving `ffa_mem_region_additional_setup()` earlier in the setup
flow.
Also, add sanity checks to ensure the calculated descriptor offsets do not
exceed `max_fragsize`. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Fix out-of-bound writes in ffa_setup_and_transmit()
Sashiko (locally) reports multiple out-of-bound issues in
ffa_setup_and_transmit:
1) Writing ep_mem_access->reserved can write out of bounds for FFA
versions < 1.2 as ffa_emad_size_get() returns 16 bytes in that case
while reserved has an offset of 24.
Instead of zeroing fields, memset the struct to zero first based on
the FFA version.
2) Make sure there is enough size to write constituents.
While at it, convert the only sizeof() in the driver that uses a
type instead of variable. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: use wiphy work for socket owner autodisconnect
nl80211_netlink_notify() walks the cfg80211 wireless device list when a
NETLINK_GENERIC socket is released. If the socket owns a connection, the
notifier queues the embedded wdev->disconnect_wk work item.
That work is a plain work_struct today. NETDEV_GOING_DOWN cancels it, but a
NETLINK_URELEASE notifier that already observed conn_owner_nlportid can
queue it after that cancel returns. _cfg80211_unregister_wdev() then
removes the wdev from the list and waits for RCU readers, but
synchronize_net() does not drain work queued by such a reader.
Make the autodisconnect work a wiphy_work instead. The callback already
needs the wiphy mutex, and wiphy_work runs under that mutex. This lets
teardown cancel pending autodisconnect work while holding the mutex,
without a cancel_work_sync() vs. worker locking concern.
Also cancel the wiphy work after list_del_rcu() and synchronize_net(). Any
NETLINK_URELEASE notifier that had already reached the wdev list has then
either queued the work and it is removed, or can no longer find the wdev. |
| A flaw was found in multicluster-global-hub. During a ManagedClusterMigration, the system incorrectly grants all managed hubs read access to a shared communication topic. This allows a compromised managed hub to intercept and collect sensitive bootstrap kubeconfigs, which contain API server tokens intended for other hubs. These tokens have an extended validity of approximately 9.86 years, significantly increasing the risk of unauthorized access and information disclosure to other managed clusters. |
| A flaw was found in libvirt. During storage volume clone or convert operations, newly created volume images were temporarily world-readable. This was caused by the `qemu-img` utility running with overly permissive file creation settings, allowing any local user to read the full guest disk contents. This vulnerability could lead to sensitive information disclosure from guest virtual machines. |
| Improper export of android application components in AppLock prior to SMR Aug-2026 Release 1 allows physical attackers to bypass app lock function. |
| A flaw was found in multicluster-global-hub. The manager component improperly validates the source identity of incoming CloudEvents on Kafka status topics. A remote attacker, after compromising a managed hub and obtaining its Kafka client certificate, can manipulate the self-asserted source identity. This allows the attacker to falsify or delete critical data, such as compliance, inventory, and cluster health information, belonging to other hubs in the database. |
| An Insecure Deserialization vulnerability in WatchGuard Fireware OS allows an attacker that has obtained write access to the local filesystem through another vulnerability to execute arbitrary code in the context of the portald user.
Note, this vulnerability does not affect Firebox platforms that do not support the Access Portal feature, including the T15 and T35. |
| Authorization bypass in SemClipboardService prior to SMR Aug-2026 Release 1 allows local attackers to access clipboard data. |
| Improper input validation in Samsung Dialer prior to SMR Aug-2026 Release 1 allows remote attackers to access SIM related functions. User interaction is required for triggering this vulnerability. |
| A Cross-Site Request Forgery (CSRF) vulnerability in the WatchGuard Fireware OS WebUI could allow a remote attacker to trigger a denial-of-service (DoS) condition in the Fireware Web UI by convincing an authenticated administrator into visiting a malicious web page. |
