| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the WebVPN login process of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause increased CPU utilization on an affected device. The vulnerability is due to excessive processing load for existing WebVPN login operations. An attacker could exploit this vulnerability by sending multiple WebVPN login requests to the device. A successful exploit could allow the attacker to increase CPU load on the device, resulting in a denial of service (DoS) condition. |
| A vulnerability in the ARP packet processing of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, adjacent attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition on an affected device. The vulnerability is due to incorrect processing of ARP packets received by the management interface of an affected device. An attacker could exploit this vulnerability by sending a series of unicast ARP packets in a short timeframe that would reach the management interface of an affected device. A successful exploit could allow the attacker to consume resources on an affected device, which would prevent the device from sending internal system keepalives and eventually cause the device to reload, resulting in a denial of service (DoS) condition. |
| A vulnerability in the web interface of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. The vulnerability is due to a lack of proper input validation of HTTP requests. An attacker could exploit this vulnerability by sending a crafted HTTP request to an affected device. An exploit could allow the attacker to cause a DoS condition. Note: This vulnerability applies to IP Version 4 (IPv4) and IP Version 6 (IPv6) HTTP traffic. |
| A vulnerability in the Simple Network Management Protocol (SNMP) input packet processor of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to restart unexpectedly. The vulnerability is due to a lack of sufficient memory management protections under heavy SNMP polling loads. An attacker could exploit this vulnerability by sending a high rate of SNMP requests to the SNMP daemon through the management interface on an affected device. A successful exploit could allow the attacker to cause the SNMP daemon process to consume a large amount of system memory over time, which could then lead to an unexpected device restart, causing a denial of service (DoS) condition. This vulnerability affects all versions of SNMP. |
| A vulnerability in the VPN System Logging functionality for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak that can deplete system memory over time, which can cause unexpected system behaviors or device crashes. The vulnerability is due to the system memory not being properly freed for a VPN System Logging event generated when a VPN session is created or deleted. An attacker could exploit this vulnerability by repeatedly creating or deleting a VPN tunnel connection, which could leak a small amount of system memory for each logging event. A successful exploit could allow the attacker to cause system memory depletion, which can lead to a systemwide denial of service (DoS) condition. The attacker does not have any control of whether VPN System Logging is configured or not on the device, but it is enabled by default. |
| A vulnerability in the logging configuration of Secure Sockets Layer (SSL) policies for Cisco FirePOWER System Software 5.3.0 through 6.2.2 could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition due to high consumption of system resources. The vulnerability is due to the logging of certain TCP packets by the affected software. An attacker could exploit this vulnerability by sending a flood of crafted TCP packets to an affected device. A successful exploit could allow the attacker to cause a DoS condition. The success of an exploit is dependent on how an administrator has configured logging for SSL policies for a device. This vulnerability affects Cisco FirePOWER System Software that is configured to log connections by using SSL policy default actions. Cisco Bug IDs: CSCvd07072. |
| A vulnerability in the ICMP ingress packet processing of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 4110 appliances could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to incomplete input validation upon receiving ICMP packets. An attacker could exploit this vulnerability by sending a high number of crafted ICMP or ICMPv6 packets to an affected device. A successful exploit could allow the attacker to cause a memory exhaustion condition that may result in an unexpected reload. No manual intervention is needed to recover the device after the reload. |
| A vulnerability in the Internet Key Exchange version 1 (IKEv1) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper management of system memory. An attacker could exploit this vulnerability by sending malicious IKEv1 traffic to an affected device. The attacker does not need valid credentials to authenticate the VPN session, nor does the attacker's source address need to match a peer statement in the crypto map applied to the ingress interface of the affected device. An exploit could allow the attacker to exhaust system memory resources, leading to a reload of an affected device. |
| A vulnerability in the packet processing functionality of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to inefficient memory management. An attacker could exploit this vulnerability by sending a large number of TCP packets to a specific port on an affected device. A successful exploit could allow the attacker to exhaust system memory, which could cause the device to reload unexpectedly. No manual intervention is needed to recover the device after it has reloaded. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for the Cisco Firepower 2100 Series could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to a logic error, which may prevent ingress buffers from being replenished under specific traffic conditions. An attacker could exploit this vulnerability by sending a series of crafted packets to an affected device. A successful exploit could allow the attacker to consume all input buffers, which are shared between all interfaces, leading to a queue wedge condition in all active interfaces. This situation would cause an affected device to stop processing any incoming traffic and result in a DoS condition until the device is reloaded manually. |
| A vulnerability in the Internet Key Exchange Version 2 Mobility and Multihoming Protocol (MOBIKE) feature for the Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak or a reload of an affected device that leads to a denial of service (DoS) condition. The vulnerability is due to the incorrect processing of certain MOBIKE packets. An attacker could exploit this vulnerability by sending crafted MOBIKE packets to an affected device to be processed. A successful exploit could cause an affected device to continuously consume memory and eventually reload, resulting in a DoS condition. The MOBIKE feature is supported only for IPv4 addresses. |
| Multiple vulnerabilities in the Server Message Block (SMB) Protocol preprocessor detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent or remote attacker to cause a denial of service (DoS) condition. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| A vulnerability in the Open Shortest Path First (OSPF) implementation in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak on an affected device. The vulnerability is due to incorrect processing of certain OSPF packets. An attacker could exploit this vulnerability by sending a series of crafted OSPF packets to be processed by an affected device. A successful exploit could allow the attacker to continuously consume memory on an affected device and eventually cause it to reload, resulting in a denial of service (DoS) condition. |
| A vulnerability in the packet processing functionality of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to inefficient memory management. An attacker could exploit this vulnerability by sending a high rate of IPv4 or IPv6 traffic through an affected device. This traffic would need to match a configured block action in an access control policy. An exploit could allow the attacker to cause a memory exhaustion condition on the affected device, which would result in a DoS for traffic transiting the device, as well as sluggish performance of the management interface. Once the flood is stopped, performance should return to previous states. |
| A vulnerability in the TCP syslog module of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to exhaust the 1550-byte buffers on an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to a missing boundary check in an internal function. An attacker could exploit this vulnerability by establishing a man-in-the-middle position between an affected device and its configured TCP syslog server and then maliciously modifying the TCP header in segments that are sent from the syslog server to the affected device. A successful exploit could allow the attacker to exhaust buffer on the affected device and cause all TCP-based features to stop functioning, resulting in a DoS condition. The affected TCP-based features include AnyConnect SSL VPN, clientless SSL VPN, and management connections such as Secure Shell (SSH), Telnet, and HTTPS. |
| A vulnerability in the IP fragment-handling implementation of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak on an affected device. This memory leak could prevent traffic from being processed through the device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper error handling when specific failures occur during IP fragment reassembly. An attacker could exploit this vulnerability by sending crafted, fragmented IP traffic to a targeted device. A successful exploit could allow the attacker to continuously consume memory on the affected device and eventually impact traffic, resulting in a DoS condition. The device could require a manual reboot to recover from the DoS condition. Note: This vulnerability applies to both IP Version 4 (IPv4) and IP Version 6 (IPv6) traffic. |
| A vulnerability in the cryptographic hardware accelerator driver of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a temporary denial of service (DoS) condition. The vulnerability exists because the affected devices have a limited amount of Direct Memory Access (DMA) memory and the affected software improperly handles resources in low-memory conditions. An attacker could exploit this vulnerability by sending a sustained, high rate of malicious traffic to an affected device to exhaust memory on the device. A successful exploit could allow the attacker to exhaust DMA memory on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the Secure Sockets Layer (SSL)/Transport Layer Security (TLS) handler of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to exhaust memory resources on the affected device, leading to a denial of service (DoS) condition. The vulnerability is due to improper resource management for inbound SSL/TLS connections. An attacker could exploit this vulnerability by establishing multiple SSL/TLS connections with specific conditions to the affected device. A successful exploit could allow the attacker to exhaust the memory on the affected device, causing the device to stop accepting new SSL/TLS connections and resulting in a DoS condition for services on the device that process SSL/TLS traffic. Manual intervention is required to recover an affected device. |
| A vulnerability in the TLS 1.3 implementation for a specific cipher for Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software for Cisco Firepower 3100 and 4200 Series devices could allow an authenticated, remote attacker to consume resources that are associated with incoming TLS 1.3 connections, which eventually could cause the device to stop accepting any new SSL/TLS or VPN requests.
This vulnerability is due to the implementation of the TLS 1.3 Cipher TLS_CHACHA20_POLY1305_SHA256. An attacker could exploit this vulnerability by sending a large number of TLS 1.3 connections with the specific TLS 1.3 Cipher TLS_CHACHA20_POLY1305_SHA256. A successful exploit could allow the attacker to cause a denial of service (DoS) condition where no new incoming encrypted connections are accepted. The device must be reloaded to clear this condition.
Note: These incoming TLS 1.3 connections include both data traffic and user-management traffic. After the device is in the vulnerable state, no new encrypted connections can be accepted. |
