| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The RSA and DSA public key parsers did not enforce size limits on key parameters. A crafted public key with an excessively large modulus or DSA parameter could cause several minutes of CPU consumption during signature verification. This could be triggered by unauthenticated clients during public key authentication. RSA moduli are now limited to 8192 bits, and DSA parameters are validated per FIPS 186-2. |
| Improper Validation of Specified Quantity in Input and Allocation of Resources Without Limits or Throttling vulnerability in Samsung Open Source rlottie allows Excessive Allocation. |
| Improper Validation of Specified Quantity in Input vulnerability in Samsung Open Source rlottie allows Input Data Manipulation. |
| imagecli's pipeline operation (Carve::apply in src/image_ops.rs) only asserts , never validating that the ratio is positive. A negative ratio (e.g. -5) causes the computed target width to saturate to 0 via Rust's defined float-to-uint cast, which is then passed to imageproc::seam_carving::shrink_width — a function that panics when given a width below 2, crashing the process. |
| GNU Emacs for Android improperly validates the table header input in sfnt_read_table_directory() in src/sfnt.c. Due to an incorrect comparison variable in the read-length check, a crafted font file that claims to contain more table directory entries than actually present causes the parser to return a struct with uninitialized heap memory in the table directory entries. An attacker can deliver a malicious font file via email, EWW (Emacs Web Wowser), or documents with custom faces, causing Emacs to load it. This leads to the use of uninitialized heap data in subsequent table lookups, potentially resulting in information disclosure, crashes, or arbitrary memory access on 32-bit targets.
This issue is fixed after commit 7621ee1d01229d50e5c0cddea6bf0b01095a62cf |
| In the Linux kernel, the following vulnerability has been resolved:
ibmveth: Disable GSO for packets with small MSS
Some physical adapters on Power systems do not support segmentation
offload when the MSS is less than 224 bytes. Attempting to send such
packets causes the adapter to freeze, stopping all traffic until
manually reset.
Implement ndo_features_check to disable GSO for packets with small MSS
values. The network stack will perform software segmentation instead.
The 224-byte minimum matches ibmvnic
commit <f10b09ef687f> ("ibmvnic: Enforce stronger sanity checks
on GSO packets")
which uses the same physical adapters in SEA configurations.
The issue occurs specifically when the hardware attempts to perform
segmentation (gso_segs > 1) with a small MSS. Single-segment GSO packets
(gso_segs == 1) do not trigger the problematic LSO code path and are
transmitted normally without segmentation.
Add an ndo_features_check callback to disable GSO when MSS < 224 bytes.
Also call vlan_features_check() to ensure proper handling of VLAN packets,
particularly QinQ (802.1ad) configurations where the hardware parser may
not support certain offload features.
Validated using iptables to force small MSS values. Without the fix,
the adapter freezes. With the fix, packets are segmented in software
and transmission succeeds. Comprehensive regression testing completedd
(MSS tests, performance, stability). |
| As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco Catalyst SD-WAN engineering team has conducted a comprehensive internal security review. This review resulted in software hardening releases that address multiple internally discovered vulnerabilities.
The vulnerabilities tracked by CVE-2026-20313 are related to Improper link resolution before file access issues that are grouped under the Common Weakness Enumeration (CWE) CWE-1284. |
| H5Z__filter_nbit in H5Znbit.c in HDF5 through 2.3.0 dereferences cd_values[0] through cd_values[4] without validating that cd_values is non-NULL or that cd_nelmts is at least 5, the fixed size of the filter's header. This allows attackers to cause a denial of service via a crafted HDF5 file that stores the N-Bit filter pipeline message with zero client-data values, opened and read via H5Dread, e.g. by the h5ls or h5repack tools. |
| H5Z__filter_fletcher32 in H5Zfletcher32.c in HDF5 through 2.3.0 computes the data length to checksum by subtracting the 4-byte trailing checksum size from the input buffer size without checking that the buffer is at least 4 bytes, allowing a size_t underflow. This allows attackers to cause a denial of service (massively out-of-bounds read and application crash in H5_checksum_fletcher32) via a crafted HDF5 file with a Fletcher32-filtered chunk smaller than 4 bytes, triggered via H5Dread, e.g. by the h5ls or h5dump tools. |
| Nuxt is an open-source web development framework for Vue.js. From 3.1.0 until 3.21.10 and 4.5.1, an unauthenticated attacker can use a server island v-for prop, including vforToArray and , to trigger unbounded SSR memory allocation until MAX_VFOR_LENGTH = 100000 and crash the Nuxt process. This issue is fixed in 3.21.10 and 4.5.1. |
| In the Linux kernel, the following vulnerability has been resolved:
net: drop bad gso csum_start and offset in virtio_net_hdr
Tighten csum_start and csum_offset checks in virtio_net_hdr_to_skb
for GSO packets.
The function already checks that a checksum requested with
VIRTIO_NET_HDR_F_NEEDS_CSUM is in skb linear. But for GSO packets
this might not hold for segs after segmentation.
Syzkaller demonstrated to reach this warning in skb_checksum_help
offset = skb_checksum_start_offset(skb);
ret = -EINVAL;
if (WARN_ON_ONCE(offset >= skb_headlen(skb)))
By injecting a TSO packet:
WARNING: CPU: 1 PID: 3539 at net/core/dev.c:3284 skb_checksum_help+0x3d0/0x5b0
ip_do_fragment+0x209/0x1b20 net/ipv4/ip_output.c:774
ip_finish_output_gso net/ipv4/ip_output.c:279 [inline]
__ip_finish_output+0x2bd/0x4b0 net/ipv4/ip_output.c:301
iptunnel_xmit+0x50c/0x930 net/ipv4/ip_tunnel_core.c:82
ip_tunnel_xmit+0x2296/0x2c70 net/ipv4/ip_tunnel.c:813
__gre_xmit net/ipv4/ip_gre.c:469 [inline]
ipgre_xmit+0x759/0xa60 net/ipv4/ip_gre.c:661
__netdev_start_xmit include/linux/netdevice.h:4850 [inline]
netdev_start_xmit include/linux/netdevice.h:4864 [inline]
xmit_one net/core/dev.c:3595 [inline]
dev_hard_start_xmit+0x261/0x8c0 net/core/dev.c:3611
__dev_queue_xmit+0x1b97/0x3c90 net/core/dev.c:4261
packet_snd net/packet/af_packet.c:3073 [inline]
The geometry of the bad input packet at tcp_gso_segment:
[ 52.003050][ T8403] skb len=12202 headroom=244 headlen=12093 tailroom=0
[ 52.003050][ T8403] mac=(168,24) mac_len=24 net=(192,52) trans=244
[ 52.003050][ T8403] shinfo(txflags=0 nr_frags=1 gso(size=1552 type=3 segs=0))
[ 52.003050][ T8403] csum(0x60000c7 start=199 offset=1536
ip_summed=3 complete_sw=0 valid=0 level=0)
Mitigate with stricter input validation.
csum_offset: for GSO packets, deduce the correct value from gso_type.
This is already done for USO. Extend it to TSO. Let UFO be:
udp[46]_ufo_fragment ignores these fields and always computes the
checksum in software.
csum_start: finding the real offset requires parsing to the transport
header. Do not add a parser, use existing segmentation parsing. Thanks
to SKB_GSO_DODGY, that also catches bad packets that are hw offloaded.
Again test both TSO and USO. Do not test UFO for the above reason, and
do not test UDP tunnel offload.
GSO packet are almost always CHECKSUM_PARTIAL. USO packets may be
CHECKSUM_NONE since commit 10154dbded6d6 ("udp: Allow GSO transmit
from devices with no checksum offload"), but then still these fields
are initialized correctly in udp4_hwcsum/udp6_hwcsum_outgoing. So no
need to test for ip_summed == CHECKSUM_PARTIAL first.
This revises an existing fix mentioned in the Fixes tag, which broke
small packets with GSO offload, as detected by kselftests. |
| In the Linux kernel, the following vulnerability has been resolved:
enic: Validate length of nl attributes in enic_set_vf_port
enic_set_vf_port assumes that the nl attribute IFLA_PORT_PROFILE
is of length PORT_PROFILE_MAX and that the nl attributes
IFLA_PORT_INSTANCE_UUID, IFLA_PORT_HOST_UUID are of length PORT_UUID_MAX.
These attributes are validated (in the function do_setlink in rtnetlink.c)
using the nla_policy ifla_port_policy. The policy defines IFLA_PORT_PROFILE
as NLA_STRING, IFLA_PORT_INSTANCE_UUID as NLA_BINARY and
IFLA_PORT_HOST_UUID as NLA_STRING. That means that the length validation
using the policy is for the max size of the attributes and not on exact
size so the length of these attributes might be less than the sizes that
enic_set_vf_port expects. This might cause an out of bands
read access in the memcpys of the data of these
attributes in enic_set_vf_port. |
| Knot Resolver before 6.4.1 allows remote code execution via a heap-based buffer overflow in the DoQ (DNS-over-QUIC) receive path. |
| ** UNSUPPORTED WHEN ASSIGNED ** Improper Validation of Specified Quantity in Input in the ASUS AI Suite 3 driver allows a local user to access unintended memory regions via crafted IOCTL requests, leading to privilege escalation.
Refer to the 'End-of-Life Notice and Driver Update for Legacy ASUS Drivers ' section on the ASUS Security Advisory for more information. |
| Improper Input Validation in the decode() function of the traceparser library could allow an attacker with a corrupted kernel trace event log (.kev) file, to execute arbitrary code or cause a crash in processes that use libtraceparser in QNX hosts or targets. |
| A flaw was found in OpenStack Keystone. A remote attacker could exploit this vulnerability by sending a large HTTP request, specifically by providing a long tenant name when requesting a token. This could lead to a denial of service, consuming excessive CPU and memory resources on the affected system. |
| In the Linux kernel, the following vulnerability has been resolved:
net/mdiobus: Fix potential out-of-bounds clause 45 read/write access
When using publicly available tools like 'mdio-tools' to read/write data
from/to network interface and its PHY via C45 (clause 45) mdiobus,
there is no verification of parameters passed to the ioctl and
it accepts any mdio address.
Currently there is support for 32 addresses in kernel via PHY_MAX_ADDR define,
but it is possible to pass higher value than that via ioctl.
While read/write operation should generally fail in this case,
mdiobus provides stats array, where wrong address may allow out-of-bounds
read/write.
Fix that by adding address verification before C45 read/write operation.
While this excludes this access from any statistics, it improves security of
read/write operation. |
| ** UNSUPPORTED WHEN ASSIGNED ** Improper Validation of Specified Quantity in Input in the ASUS AI Suite 3 driver allows a local user to bypass security validation and access restricted memory blocks via crafted IOCTL requests, leading to privilege escalation.
Refer to the 'End-of-Life Notice and Driver Update for Legacy ASUS Drivers ' section on the ASUS Security Advisory for more information. |
| Allocation of Resources Without Limits or Throttling, Improper Validation of Specified Quantity in Input vulnerability in The Qt Company Qt on Windows, MacOS, Linux, iOS, Android, x86, ARM, 64 bit, 32 bit allows Excessive Allocation.
This issue affects users of the Text component in Qt Quick. Missing validation of the width and height in the <img> tag could cause an application to become unresponsive.
This issue affects Qt: from 5.0.0 through 6.5.10, from 6.6.0 through 6.8.5, from 6.9.0 through 6.10.0. |
| Unauthenticated Other Vulnerability Type in Booking and Rental Manager <= 2.7.2 versions. |
