| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| An unauthenticated command injection vulnerability exists in the Start_EPI function of the httpd binary on Linksys E1200 v2 routers (Firmware E1200_v2.0.11.001_us.tar.gz). The vulnerability occurs because user-supplied CGI parameters (wl_ant, wl_ssid, wl_rate, ttcp_num, ttcp_ip, ttcp_size) are concatenated into system command strings without proper sanitization and executed via wl_exec_cmd. Successful exploitation allows remote attackers to execute arbitrary commands on the device without authentication. |
| A flaw has been found in Linksys MR9600 2.0.6.206937. Affected is the function smartConnectConfigure of the file SmartConnect.lua. Executing a manipulation of the argument configApSsid/configApPassphrase/srpLogin/srpPassword can lead to os command injection. The attack may be launched remotely. The exploit has been published and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was identified in Linksys MR9600 2.0.6.206937. This affects the function BTRequestGetSmartConnectStatus of the file /etc/init.d/run_central2.sh of the component JNAP Action Handler. The manipulation of the argument pin leads to os command injection. The attack may be initiated remotely. The exploit is publicly available and might be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| Multiple cross-site scripting (XSS) vulnerabilities in setup.cgi on the Cisco Linksys WAG54GS Wireless-G ADSL Gateway with 1.00.06 firmware allow remote attackers to inject arbitrary web script or HTML via the (1) c4_trap_ip_, (2) devname, (3) snmp_getcomm, or (4) snmp_setcomm parameter. |
| Stack-based buffer overflow in the Broadcom BCMWL5.SYS wireless device driver 3.50.21.10, as used in Cisco Linksys WPC300N Wireless-N Notebook Adapter before 4.100.15.5 and other products, allows remote attackers to execute arbitrary code via an 802.11 response frame containing a long SSID field. |
| PhoneCtrl.exe in Linksys WIP 330 Wireless-G IP Phone 1.00.06A allows remote attackers to cause a denial of service (crash) via a TCP SYN scan, as demonstrated using TCP ports 1-65535 with nmap. |
| The web interface on the Linksys WRT54g router with firmware 1.00.9 does not require credentials when invoking scripts, which allows remote attackers to perform arbitrary administrative actions via a direct request to (1) Advanced.tri, (2) AdvRoute.tri, (3) Basic.tri, (4) ctlog.tri, (5) ddns.tri, (6) dmz.tri, (7) factdefa.tri, (8) filter.tri, (9) fw.tri, (10) manage.tri, (11) ping.tri, (12) PortRange.tri, (13) ptrigger.tri, (14) qos.tri, (15) rstatus.tri, (16) tracert.tri, (17) vpn.tri, (18) WanMac.tri, (19) WBasic.tri, or (20) WFilter.tri. NOTE: the Security.tri vector is already covered by CVE-2006-5202. |
| Multiple buffer overflows in the Marvell wireless driver, as used in Linksys WAP4400N Wi-Fi access point with firmware 1.2.17 on the Marvell 88W8361P-BEM1 chipset, and other products, allow remote 802.11-authenticated users to cause a denial of service (wireless access point crash) and possibly execute arbitrary code via an association request with long (1) rates, (2) extended rates, and unspecified other information elements. |
| The Marvell driver for the Linksys WAP4400N Wi-Fi access point with firmware 1.2.14 on the Marvell 88W8361P-BEM1 chipset, when WEP mode is enabled, does not properly parse malformed 802.11 frames, which allows remote attackers to cause a denial of service (reboot or hang-up) via a malformed association request containing the WEP flag, as demonstrated by a request that is too short, a different vulnerability than CVE-2008-1144 and CVE-2008-1197. |
| The Linksys WRT54G router allows remote attackers to cause a denial of service (device restart) via a long username and password to the FTP interface. |
| Multiple cross-site request forgery (CSRF) vulnerabilities on the Cisco Linksys WAG54GS Wireless-G ADSL Gateway with 1.01.03 and earlier firmware allow remote attackers to perform actions as administrators via an arbitrary valid request to an administrative URI, as demonstrated by (1) a Restore Factory Defaults action using the mtenRestore parameter to setup.cgi and (2) creation of a user account using the sysname parameter to setup.cgi. |
| The Linksys WAG200G with firmware 1.01.01, WRT54GC 2 with firmware 1.00.7, and WRT54GC 1 with firmware 1.03.0 and earlier allow remote attackers to obtain sensitive information (passwords and configuration data) via a packet to UDP port 916. NOTE: some of these details are obtained from third party information. |
| Cross-site scripting (XSS) vulnerability on the Linksys WRT300N router with firmware 2.00.20, when Mozilla Firefox or Apple Safari is used, allows remote attackers to inject arbitrary web script or HTML via the dyndns_domain parameter to the default URI. |
| Cross-site request forgery (CSRF) vulnerability in apply.cgi in the Linksys WRT54GL Wireless-G Broadband Router with firmware 4.30.9 allows remote attackers to perform actions as administrators. |
| The HTTP server in Linksys SPA-921 VoIP Desktop Phone allows remote attackers to cause a denial of service (reboot) via (1) a long URL, or a long (2) username or (3) password during Basic Authentication. |
| Buffer overflow on the Linksys WRT54GL wireless router allows remote attackers to execute arbitrary code via unspecified vectors, as demonstrated by a certain module in VulnDisco Pack Professional 8.10 through 8.11. NOTE: as of 20090917, this disclosure has no actionable information. However, because the VulnDisco Pack author is a reliable researcher, the issue is being assigned a CVE identifier for tracking purposes. |
| The Linksys WRT54G router has "admin" as its default FTP password, which allows remote attackers to access sensitive files including nvram.cfg, a file that lists all HTML documents, and an ELF executable file. |
| Linksys WRT54g firmware 1.00.9 does not require credentials when making configuration changes, which allows remote attackers to modify arbitrary configurations via a direct request to Security.tri, as demonstrated using the SecurityMode and layout parameters, a different issue than CVE-2006-2559. |
| The Cisco Linksys WAG54GS Wireless-G ADSL Gateway with 1.01.03 and earlier firmware has "admin" as its default password for the "admin" account, which makes it easier for remote attackers to obtain access. |
| Cross-site scripting (XSS) vulnerability in the Linksys SPA941 VoIP Phone with firmware 5.1.8 allows remote attackers to inject arbitrary web script or HTML via the From header in a SIP message. |
